MODEL: KSP

KSP SPECIFICATIONS

ES-3572 Rev.8 Page 2/3

http://www.m-system.co.jp/

Low-end cutout: 2 to 5 %

(For /DN option, the output signal may fluctuate when the

input signal is less than 5 %.)

INPUT SPECIFICATIONS

Frequency range: 0 – 50 Hz through 10 kHz

Pulse width (time) requirement: Duty ratio 20 – 80 % at 100

% input

■ Dry Contact: Mechanical contact or open collector

Sensing: Approx. 7.5 V DC @1 mA

ON/OFF level: ≤ 200 Ω / 0.6 V for ON, ≥ 100 kΩ / 2 V for OFF

■ Voltage Pulse: Square or sine waveforms

Pulse sensing: Capacitor coupled; detecting pulse rise

Input amplitude: 2 – 50 Vp-p

Input impedance: 100 kΩ min.

OUTPUT SPECIFICATIONS

■ DC Current: 0 – 20 mA DC

Minimum span: 1 mA

Offset: Max. 1.5 times span

Load resistance: Output drive 15 V max.

■ DC Voltage: -10 – +12 V DC

Minimum span: 5 mV

Offset: Max. 1.5 times span

Load resistance: Output drive 10 mA max.; 5 mA for

negative voltage output; at ≥ 0.5 V

INSTALLATION

Power input

•AC: Operational voltage range: rating ±10 %,

50/60 ± 2 Hz, approx. 2.5 VA

•DC: Operational voltage range: rating ±10 %,

ripple 10% p-p max.; approx. 2.5 W (100 mA at 24 V)

Operating temperature: -5 to +55°C (23 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Surface or DIN rail

Weight: 350 g (0.77 lb)

PERFORMANCE in percentage of span

Accuracy: ± 0.3 % (output 10 – 100 %)

Temp. coefficient: ±0.02 %/°C (±0.01 %/°F)

Response time: (0 – 90 %)

Approx. 2 sec. for 0 – 50 Hz

Approx. 1 sec. for 0 – 100 Hz

Approx. 0.5 sec. for 0 – 500 Hz

Approx. 0.5 sec. for 0 – 10 kHz

Ripple: 0.2 %p-p max. with input ≥ 10 %

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @1 minute (input to output

to power to ground)