ATmega165 datasheet(255/336 Pages) ATMEL

255 / 336 page

255

ATmega165/V

2573G–AVR–07/09

K: Repeat 3 through 5 until the entire buffer is filled.

L: Program EEPROM page

Set BS to “0”.

Give WR a negative pulse. This starts programming of the EEPROM page.

RDY/BSY goes low.

Wait until to RDY/BSY goes high before programming the next page (See Figure

114 for signal waveforms).

Figure 114. Programming the EEPROM Waveforms

Reading the Flash

The algorithm for reading the Flash memory is as follows (refer to “Programming the

Flash” on page 252 for details on Command and Address loading):

A: Load Command “0000 0010”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

Set OE to “0”, and BS1 to “0”. The Flash word low byte can now be read at DATA.

Set BS to “1”. The Flash word high byte can now be read at DATA.

Set OE to “1”.

Reading the EEPROM

The algorithm for reading the EEPROM memory is as follows (refer to “Programming the

Flash” on page 252 for details on Command and Address loading):

A: Load Command “0000 0011”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

Set OE to “0”, and BS1 to “0”. The EEPROM Data byte can now be read at

DATA.

Set OE to “1”.

RDY/BSY

RESET +12V

PAGEL

BS2

0x11

ADDR. HIGH

DATA

ADDR. LOW

DATA

ADDR. LOW

DATA

XA1

XA0

BS1

XTAL1

ATmega165 Datasheet(PDF) 255 Page - ATMEL Corporation

ATmega165 Datasheet(HTML) 255 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL