ATmega16A datasheet(113/352 Pages) ATMEL

113 / 352 page

113

8154B–AVR–07/09

ATmega16A

• Bit 6 – ICES1: Input Capture Edge Select

This bit selects which edge on the Input Capture Pin (ICP1) that is used to trigger a capture

event. When the ICES1 bit is written to zero, a falling (negative) edge is used as trigger, and

when the ICES1 bit is written to one, a rising (positive) edge will trigger the capture.

When a capture is triggered according to the ICES1 setting, the counter value is copied into the

Input Capture Register (ICR1). The event will also set the Input Capture Flag (ICF1), and this

can be used to cause an Input Capture Interrupt, if this interrupt is enabled.

When the ICR1 is used as TOP value (see description of the WGM13:0 bits located in the

TCCR1A and the TCCR1B Register), the ICP1 is disconnected and consequently the Input Cap-

ture function is disabled.

• Bit 5 – Reserved Bit

This bit is reserved for future use. For ensuring compatibility with future devices, this bit must be

written to zero when TCCR1B is written.

• Bit 4:3 – WGM13:2: Waveform Generation Mode

See TCCR1A Register description.

• Bit 2:0 – CS12:0: Clock Select

The three Clock Select bits select the clock source to be used by the Timer/Counter, see Figure

16-10 and Figure 16-11.

If external pin modes are used for the Timer/Counter1, transitions on the T1 pin will clock the

counter even if the pin is configured as an output. This feature allows software control of the

counting.

16.11.3

TCNT1H and TCNT1L –Timer/Counter1 High and Low Register

The two Timer/Counter I/O locations (TCNT1H and TCNT1L, combined TCNT1) give direct

access, both for read and for write operations, to the Timer/Counter unit 16-bit counter. To

Table 16-6.

Clock Select Bit Description

CS12

CS11

CS10

Description

No clock source (Timer/Counter stopped).

clk

I/O/1 (No prescaling)

clkI/O/8 (From prescaler)

clk

I/O/64 (From prescaler)

clk

I/O/256 (From prescaler)

clkI/O/1024 (From prescaler)

External clock source on T1 pin. Clock on falling edge.

External clock source on T1 pin. Clock on rising edge.

Bit

765

210

TCNT1[15:8]

TCNT1H

TCNT1[7:0]

TCNT1L

Read/Write

R/W

Initial Value

ATmega16A Datasheet(PDF) 113 Page - ATMEL Corporation

ATmega16A Datasheet(HTML) 113 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL