DOC7707 datasheet(199/307 Pages) ETC1

199 / 307 page

199

7707F–AVR–11/10

AT90USB82/162

ADDEN is cleared by hardware:

• after a power-up reset,

• when an USB reset is received,

• or when the macro is disabled (USBE cleared)

When this bit is cleared, the default device address 00h is used.

20.8

Suspend, Wake-up and Resume

After a period of 3 ms during which the USB line was inactive (J state), the controller setn the

SUSPI flag and triggers the corresponding interrupt if enabled. The firmware may then set the

FRZCLK bit.

The CPU can also, depending on software architecture, disable the PLL and/or enter in the idle

mode to reduce the power consumption (especially in a bus powered application).

There are two ways to recover from the “Suspend” mode:

• First one is to clear the FRZCLK bit. This is possible if the CPU is not in the Idle mode.

• Second way, if the CPU is “idle”, is to enable the WAKEUPI interrupt (WAKEUPE set). Then,

as soon as an non-idle signal is seen by the controller, the WAKEUPI interrupt is triggered.

The firmware shall then clear the FRZCLK bit to restart the transfer.

There are no relationship between the SUSPI interrupt and the WAKEUPI interrupt: the WAKE-

UPI interrupt is triggered as soon as there are non-idle patterns on the data lines. Thus, the

WAKEUPI interrupt can occurs even if the controller is not in the “suspend” mode.

When the WAKEUPI interrupt is triggered, if the SUSPI interrupt bit was already set, it is cleared

by hardware.

When the SUSPI interrupt is triggered, if the WAKEUPI interrupt bit was already set, it is cleared

by hardware.

20.9

Detach

The reset value of the DETACH bit is 1.

It is possible to re-enumerate a device, simply by setting and clearing the DETACH bit (the line

discharge time must be taken in account).

• When the USB device controller is in full-speed mode, setting DETACH will disconnect the

pull-up on the D+ . Then, clearing DETACH will connect the pull-up on the D+.

Figure 20-3. Detach a device in Full-speed:

EN=1

D +

UVREF

D -

Detach, then

Attach

EN=1

D +

UVREF

D -

DOC7707 Datasheet(PDF) 199 Page - List of Unclassifed Manufacturers

DOC7707 Datasheet(HTML) 199 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL