18F8680 datasheet(172/496 Pages) MICROCHIP

172 / 496 page

PIC18F6585/8585/6680/8680

DS30491C-page 170

 2004 Microchip Technology Inc.

15.2.3

SOFTWARE INTERRUPT

When the Capture mode is changed, a false capture

interrupt may be generated. The user should keep bit

CCPxIE (PIE registers) clear to avoid false interrupts

and should clear the flag bit, CCPxIF, following any

such change in operating mode.

15.2.4

CCP PRESCALER

There are four prescaler settings specified by bits

CCPxM3:CCPxM0. Whenever the CCPx module is

turned off, or the CCPx module is not in Capture mode,

the prescaler counter is cleared. This means that any

Reset will clear the prescaler counter.

Switching from one capture prescaler to another may

generate an interrupt. The prescaler counter will not be

cleared; therefore, the first capture may be from a

non-zero

prescaler.

Example 15-1

shows

the

recommended method for switching between capture

prescalers. This example also clears the prescaler

counter and will not generate the “false” interrupt.

15.2.5

CAN MESSAGE TIME-STAMP

The CAN capture event occurs when a message is

received in any of the receive buffers. When config-

ured, the CAN module provides the trigger to the CCP1

module to cause a capture event. This feature is

provided to time-stamp the received CAN messages.

This feature is enabled by setting the CANCAP bit of

the CAN I/O Control register (CIOCON<4>). The

message receive signal from the CAN module then

takes the place of the events on RC2/CCP1.

EXAMPLE 15-1:

CHANGING BETWEEN

CAPTURE PRESCALERS

FIGURE 15-1:

CAPTURE MODE OPERATION BLOCK DIAGRAM

CLRF

CCP1CON

; Turn CCP module off

MOVLW

NEW_CAPT_PS

; Load WREG with the

; new prescaler mode

; value and CCP ON

MOVWF

CCP1CON

; Load CCP1CON with

; this value

CCPR1H

CCPR1L

TMR1H

TMR1L

Set Flag bit CCP1IF

TMR3

Enable

Q’s

CCP1CON<3:0>

CCP1 pin

Prescaler

÷ 1, 4, 16

and

Edge Detect

TMR3H

TMR3L

TMR1

Enable

T3CCP2

CCPR2H

CCPR2L

TMR1H

TMR1L

Set Flag bit CCP2IF

TMR3

Enable

Q’s

CCP2CON<3:0>

CCP2 pin

Prescaler

÷ 1, 4, 16

and

Edge Detect

TMR3H

TMR3L

TMR1

Enable

T3CCP2

T3CCP1

T3CCP2

T3CCP1

18F8680 Datasheet(PDF) 172 Page - Microchip Technology

18F8680 Datasheet(HTML) 172 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL