+

½ LM2903

Vref

Vin

+

½ LM2903

Vin-

Vin+

LM193, LM293, LM293A, LM393, LM393A, LM2903, LM2903V

SLCS005Y – OCTOBER 1979 – REVISED JUNE 2015

www.ti.com

8 Application and Implementation

NOTE

Information in the following applications sections is not part of the TI component

specification, and TI does not warrant its accuracy or completeness. TI’s customers are

responsible for determining suitability of components for their purposes. Customers should

validate and test their design implementation to confirm system functionality.

8.1 Application Information

LM2903 will typically be used to compare a single signal to a reference or two signals against each other. Many

users take advantage of the open drain output to drive the comparison logic output to a logic voltage level to an

MCU or logic device. The wide supply range and high voltage capability makes LM2903 optimal for level shifting

to a higher or lower voltage.

8.2 Typical Application

Figure 7. Single-Ended and Differential Comparator Configurations

8.2.1 Design Requirements

For this design example, use the parameters listed in Table 1 as the input parameters.

Table 1. Design Parameters

DESIGN PARAMETER

EXAMPLE VALUE

Input Voltage Range

0 V to Vsup-1.5 V

Supply Voltage

2 V to 36 V

Logic Supply Voltage

2 V to 36 V

1 µA to 20 mA

Input Overdrive Voltage

100 mV

Reference Voltage

2.5 V

15 pF

8.2.2 Detailed Design Procedure

When using LM2903 in a general comparator application, determine the following:

•

Input Voltage Range

•

Minimum Overdrive Voltage

•

Output and Drive Current

•

Response Time

8.2.2.1 Input Voltage Range

incorrect comparisons.

Below is a list of input voltage situation and their outcomes:

10

Submit Documentation Feedback

Copyright © 1979–2015, Texas Instruments Incorporated

Product Folder Links: LM193 LM293 LM293A LM393 LM393A LM2903 LM2903V