10TS-5G0-R
AI

The **10TS-5G0-R** is a specific electronic component, typically categorized as a **DIP (Dual In-line Package) Switch**. These switches are used on printed circuit boards (PCBs) to manually set configurations, binary codes, or hardware addresses.
Below is a detailed breakdown of its specifications and physical characteristics.
---
### 1. General Specifications
The part number usually corresponds to a **5-position** tactile or DIP-style switch.
| Feature | Specification |
| :--- | :--- |
| **Component Type** | DIP Switch / Program Switch |
| **Number of Positions** | 5 (Selectable switches) |
| **Actuator Style** | Raised / Slide |
| **Mounting Type** | Through-Hole (THT) |
| **Pitch (Spacing)** | 2.54mm (0.1 inch) Standard |
| **Contact Material** | Gold-plated (typically) for corrosion resistance |
---
### 2. Electrical Characteristics
These switches are designed for low-power signal switching rather than high-power loads.
* **Switching Capacity:** Usually 25mA at 24V DC.
* **Non-Switching Rating:** 100mA at 50V DC.
* **Contact Resistance:** Typically < 50mΩ initially.
* **Insulation Resistance:** > 100MΩ at 500V DC.
* **Dielectric Strength:** 500V AC for 1 minute.
---
### 3. Mechanical & Environmental Features
The "R" in the suffix often denotes specific packaging or environmental compliance (such as RoHS).
* **Operating Temperature:** -20°C to +85°C (Industrial Grade).
* **Durability:** Mechanical life of approximately 2,000 to 5,000 cycles per switch.
* **Material:** High-temperature Thermoplastic (UL94V-0 rated) to withstand soldering heat.
* **Seal:** Often comes with a top-tape seal to prevent flux contamination during wave soldering.
---
### 4. Common Applications
* **Network Equipment:** Setting IP addresses or hardware IDs.
* **Industrial Controls:** Configuring baud rates or operational modes.
* **Consumer Electronics:** Garage door openers (security codes) or PC peripherals.
* **Prototyping:** Manually toggling logic levels (High/Low) on a breadboard.
---
### 5. Circuit Diagram (Internal)
Each position on the 5-G0-R acts as an independent Single Pole Single Throw (SPST) switch.
```text
[Top View]
1 2 3 4 5
ON ON ON ON ON
| | | | | | | | | |
|S| |S| |S| |S| |S| <-- Sliders
|_| |_| |_| |_| |_|
| | | | |
(Common Pins Below)
```
- ⤷
What are the differences between through-hole and SMD versions of this switch?
- ⤷ How do I calculate the pull-up resistor value for use with this DIP switch?
- ⤷ Is the 10TS-5G0-R compatible with lead-free soldering processes?