The **ATS-17H-83-C2-R0** is a high-performance electronic thermal management component, specifically an **Advanced Thermal Solutions (ATS) Push-Pin Heat Sink**. It is designed to dissipate heat from electronic components like CPUs, GPUs, or power modules. --- ### 1. Technical Specifications The part number follows a specific nomenclature used by Advanced Thermal Solutions. Here are the core specifications: | Parameter | Details | | :--- | :--- | | **Manufacturer** | Advanced Thermal Solutions, Inc. (ATS) | | **Heat Sink Type** | Push-Pin (Push-pin with springs) | | **Material** | Aluminum | | **Finish** | Blue Anodized | | **Thermal Resistance** | 1.62°C/W (at 200 LFM) | | **Attachment Method** | Push-Pin (Plastic or Brass) | | **Dimensions** | 30mm x 30mm x 30mm | | **Fin Pattern** | Cross-Cut (Pin Fin) | --- ### 2. Breakdown of the Part Number Understanding the "ATS-17H-83-C2-R0" code helps in identifying its properties: * **ATS-17H**: The specific series of push-pin heat sinks. * **83**: Refers to the specific size/geometry template. * **C2**: Indicates the material and finish (typically Aluminum with a Blue Anodize). * **R0**: Indicates the revision or specific spring/pin configuration. --- ### 3. Key Features & Applications #### Features * **High Efficiency:** The "Cross-Cut" or "Pin-Fin" design allows for multi-directional airflow, making it ideal for systems where the air direction might change or is turbulent. * **Pre-assembled Attachment:** It comes with pre-drilled holes and push-pins with springs to provide a specific "pressure" (load) against the chip for maximum thermal transfer. * **Pre-applied TIM:** Often comes with high-performance **Thermal Interface Material (TIM)** pre-applied to the base to simplify installation. #### Typical Applications 1. **Telecommunications:** Cooling of networking switches and routers. 2. **Industrial PC:** Thermal management for embedded processors. 3. **Power Supplies:** Cooling voltage regulators and high-heat transistors. --- ### 4. Thermal Performance Comparison The effectiveness of this heat sink depends on the airflow (measured in Linear Feet per Minute - LFM): | Airflow (LFM) | Thermal Resistance (°C/W) | | :--- | :--- | | 100 (Unducted) | 2.15 | | 200 (Unducted) | 1.62 | | 300 (Unducted) | 1.35 |