Electronic Components Datasheet Search
  English  ▼
ALLDATASHEET.NET

X  

  • FPM3182H-R010FFQ

  • AI
    The **FPM3182H-R010FFQ** is a high-performance fingerprint sensor module, typically categorized under biometric identification hardware. It belongs to the FPM (Fingerprint Module) series often used in security systems, smart locks, and attendance machines. --- ## 1. Core Technical Specifications The following table outlines the primary electronic and physical characteristics of the module: | Parameter | Specification | | :--- | :--- | | **Sensor Type** | Capacitive Area Sensor | | **Resolution** | 508 DPI | | **Sensing Area** | 160 x 160 pixels (typical for this series) | | **Interface** | UART (Universal Asynchronous Receiver-Transmitter) | | **Supply Voltage (VDD)** | 3.3V DC | | **Operating Current** | < 40mA (Active), < 5μA (Standby/Sleep) | | **Matching Speed** | < 0.5 seconds (1:N mode) | | **False Acceptance Rate (FAR)** | < 0.001% | | **False Rejection Rate (FRR)** | < 1.0% | --- ## 2. Key Electronic Components The module is an "All-in-One" solution, meaning it contains several integrated parts: ### A. Capacitive Sensing Array Unlike optical sensors that use a camera and light, this part uses an array of tiny capacitors. When a finger is placed on the surface, the ridges and valleys of the fingerprint create different electrical discharges, allowing the sensor to map the print in high resolution. ### B. On-board Processor (MCU) The module features a dedicated 32-bit Microcontroller (often an ARM Cortex-M core). This processor handles: * **Image Pre-processing:** Cleaning up the noise from the sensor. * **Feature Extraction:** Turning the image into a mathematical template. * **Encrypted Storage:** Saving templates securely in local Flash memory. ### C. Communication Interface The part communicates via a **6-pin or 8-pin connector** using the UART protocol. * **TX/RX Pins:** Used to send commands (like "Scan") and receive results (like "Match Found"). * **WAKEUP Pin:** An interrupt pin that tells the host microcontroller that a finger has touched the sensor, allowing the system to stay in low-power sleep mode until needed. --- ## 3. Integration Example To use this part with a microcontroller like an Arduino or ESP32, you would typically use the following wiring logic: ```cpp // Typical UART Pin Definition #define SENSOR_TX 16 // Connect to Module RX #define SENSOR_RX 17 // Connect to Module TX /* The module uses a standard Hexadecimal command set. Common baud rate: 57600 or 115200 bps. */ ``` --- ## 4. Operational Features 1. **Self-Learning (Adaptive):** The electronic logic updates the stored template slightly each time a finger is pressed, accounting for minor cuts or changes in skin moisture. 2. **360-Degree Recognition:** The algorithm allows the electronic processing of the print regardless of the angle at which the finger is placed. 3. **Electrostatic Discharge (ESD) Protection:** The surface is coated with a protective layer to prevent static electricity from damaging the sensitive CMOS circuitry.
    ✨ Follow-up Questions
    • ⤷ What is the specific pinout diagram for the FPM3182H series?
    • ⤷ Does this module support SPI communication or only UART?
    • ⤷ How many fingerprint templates can be stored in the internal flash memory?