M24C32-RMB3TPP
AI

The **M24C32-RMB3TPP** is a specific variant of the M24C32 family, which is a 32-Kbit serial I2C EEPROM (Electrically Erasable Programmable Read-Only Memory) manufactured by **STMicroelectronics**.
Below is a breakdown of its technical specifications and features.
---
### 1. Key Technical Specifications
| Parameter | Specification |
| :--- | :--- |
| **Memory Size** | 32 Kbit (4,096 x 8 bits) |
| **Interface** | I2C (Serial 2-Wire) |
| **Clock Frequency** | Up to 1 MHz (Fast-Mode Plus) |
| **Operating Voltage** | 1.8V to 5.5V |
| **Package Type** | UFDFPN8 (Ultra-thin Fine pitch Dual Flat No-lead) |
| **Write Cycle Time** | 5 ms (Max) |
| **Data Retention** | 40 Years (Minimum) |
| **Endurance** | 4 Million Write Cycles |
---
### 2. Part Number Breakdown (Suffix Deciphering)
To understand the specific "RMB3TPP" suffix, we look at the ST nomenclature:
* **M24C32**: Base Part Number (I2C EEPROM, 32Kb).
* **-R**: Indicates the device operates in the **1.8V to 5.5V** range.
* **MB**: Refers to the **UFDFPN8** (MLP8) package (2x3 mm size).
* **3**: Indicates the device is **Grade 3** (Temperature range: -40°C to +125°C).
* **TP**: Indicates **Tape and Reel** packing.
* **P**: Indicates **High Reliability** or RoHS compliant/Green process.
---
### 3. Core Features
#### A. I2C Interface Details
The device acts as a slave on the I2C bus. It utilizes a 2-wire protocol consisting of:
* **SCL (Serial Clock):** Used to synchronize data transfers.
* **SDA (Serial Data):** Bi-directional line for address and data.
#### B. Write Protection
The chip includes a **Write Control (WC)** pin.
* If connected to $V_{CC}$, the entire memory is write-protected.
* If connected to $V_{SS}$ (Ground), the memory is enabled for write operations.
#### C. Page Write Buffer
It features a **32-byte page write buffer**, allowing up to 32 bytes to be written in a single instruction cycle, which significantly improves write efficiency compared to byte-by-byte writing.
---
### 4. Typical Application Circuit
In a standard microcontroller environment, the connection would look like this:
```cpp
// Logic Representation
VCC ---- [10k Pull-up] ---- SDA Line
VCC ---- [10k Pull-up] ---- SCL Line
[MCU] (Master) [M24C32] (Slave)
SDA <----------------------> SDA
SCL -----------------------> SCL
GND -----------------------> WC (to enable writing)
```
- ⤷
What are the differences between M24C32 and M24C64 in terms of addressing?
- ⤷ How does the 'Grade 3' temperature rating affect its use in automotive applications?
- ⤷ What is the physical footprint size of the UFDFPN8 package?