The **M2RS1-14-R** typically refers to a specific configuration of a **Pin Header Connector**, often associated with manufacturers like Sullins Connector Solutions or similar electronic hardware providers. Below is a detailed breakdown of its electronic and physical characteristics. --- ### 1. Technical Specifications The part number follows a modular naming convention. Here are the common specifications for this series: | Property | Description | | :--- | :--- | | **Part Type** | Male Pin Header | | **Pitch** | 2.00 mm (0.079") | | **Number of Positions** | 14 Positions | | **Number of Rows** | Single Row (1) | | **Mounting Type** | Right Angle, Through-Hole | | **Termination** | Solder | | **Contact Material** | Phosphor Bronze or Brass | | **Contact Finish** | Gold or Tin (R-suffix often denotes Gold Flash/RoHS) | --- ### 2. Component Breakdown The alphanumeric code explains the physical build of the part: * **M2**: Refers to the series (2.00mm pitch). * **RS1**: Indicates a **R**ight-Angle, **S**ingle-row configuration. * **14**: The total number of pins/circuits (14 pins in one row). * **R**: Generally indicates **RoHS Compliance** or a specific plating/packaging variation (Right-angle orientation is already covered by RS). --- ### 3. Key Applications These connectors are standard in the electronics industry for board-to-board or wire-to-board connections: 1. **Embedded Systems:** Connecting sensor modules to a main PCB. 2. **Display Interfaces:** Used to link LCD screens to microcontrollers. 3. **Prototyping:** Found on development boards (like Arduino/Raspberry Pi variants) for low-profile headers. 4. **Peripheral Expansion:** Connecting daughterboards where space is limited and a right-angle exit is required. --- ### 4. Footprint Example (Simplified) If you are designing a PCB, the layout for a 2.00mm 14-pin header would look like this in a script-based format: ```python # Pseudo-code for PCB Footprint Generation connector = PCB_Component("M2RS1-14-R") connector.set_pitch(2.00) # mm connector.set_rows(1) connector.set_pads(14) connector.set_orientation("Right-Angle") # The X-dimension would be approximately (14 * 2.00mm) = 28.0mm ``` ---