Electronic Components Datasheet Search
  English  ▼
ALLDATASHEET.NET

X  

  • MFBA2V1608-301-R

  • AI
    The **MFBA2V1608-301-R** is a Surface Mount Device (SMD) **Ferrite Chip Bead** primarily used for EMI (Electromagnetic Interference) suppression in electronic circuits. It is designed to filter out high-frequency noise while allowing DC and low-frequency signals to pass through. --- ### 1. Key Specifications The part number follows a standard nomenclature used by manufacturers (like Eaton or Bourns). Below are the technical characteristics: | Parameter | Specification | Description | | :--- | :--- | :--- | | **Impedance** | 300 $\Omega$ | Measured at 100 MHz frequency. | | **Tolerance** | ±25% | The allowable variance in impedance. | | **DC Resistance (DCR)** | ~0.20 $\Omega$ (Max) | Resistance to direct current. | | **Rated Current** | 500 mA - 600 mA | Maximum continuous current it can handle. | | **Package Size** | 1608 (Metric) / 0603 (Imperial) | Dimensions: 1.6mm x 0.8mm. | | **Operating Temp** | -55°C to +125°C | Thermal operating range. | --- ### 2. Functional Characteristics Ferrite beads like the MFBA2V1608 series act as a high-frequency resistor. * **Noise Absorption:** Unlike an inductor which reflects noise back to the source, a ferrite bead dissipates high-frequency noise as a tiny amount of heat. * **Low Frequency Path:** At low frequencies (or DC), the bead has very low impedance, acting almost like a standard wire. * **High Frequency Barrier:** At frequencies near 100MHz, the impedance rises significantly (to 300 Ohms), blocking EMI. --- ### 3. Applications This specific part is commonly found in the following areas: * **Power Lines:** Filtering DC power rails for microcontrollers and sensors. * **Data Lines:** Preventing noise on USB, HDMI, or high-speed communication lines. * **Consumer Electronics:** Used in smartphones, tablets, and wearable devices due to its small 0603 footprint. * **I/O Ports:** Reducing radiated emissions from cables and connectors. --- ### 4. Circuit Implementation In a typical schematic, the ferrite bead is placed in series with the signal or power line that needs filtering. ```markdown [Power Source] ----( Ferrite Bead )---- [Sensitive IC VCC] | [Decoupling Cap] | [GND] ``` ---
    ✨ Follow-up Questions
    • ⤷ What is the difference between a ferrite bead and a standard inductor?
    • ⤷ How does temperature affect the impedance of the MFBA2V1608-301-R?
    • ⤷ Can I use this bead for a power line carrying 1 Ampere?