●Zero power consumption at no-load with lowest system cost (< 5 mW at 230 VAC with typical application circuit)
●Intelligent low power management achieves ultra-low operating current at no-load
●Adaptive load transient detection and fast response
●Very tight constant voltage and constant current regulation over entire operating range
●PrimAccurateTM primary-side feedback eliminates optocouplers and simplifies design
●EZ-EMI TM design enhances manufacturability
●Intrinsically low common mode noise
●Optimized 72kHz maximum PWM switching frequency achieves best size and efficiency
●Active start-up scheme enables fastest possible start-up
●Adaptive multi-mode PWM/PFM control improves efficiency
●Quasi-resonant operation for highest overall efficiency
●Direct drive of low-cost BJT switch
●No external compensation components required
●Complies with EPA 2.0 energy-efficiency specifications with ample margin
●Built-in soft start
●Built-in short circuit protection and output overvoltage protection
●Built-in current sense resistor short circuit protection
●No audible noise over entire operating range