General description
The PCA9535 provides 16 bits of General Purpose Input/Output (GPIO) expansion for
I²C-bus/SMBus applications. It is designed for a wide voltage range of 2.3 V to 5.5 V with interrupt.
Nexperia GPIO expanders provide an elegant solution when additional IOs are needed while
keeping the interconnections to a minimum, for example, in ACPI power switches, sensors, push
buttons, LEDs and fan control. The PCA9535 contains a set of 8 bit Input, Output, Configuration
and Polarity inversion registers. At power up all IOs default to inputs. Each IO can be configured as
either input or output by changing the corresponding bit in the configuration register. The data for
each input or output is stored in the corresponding input or output register. The polarity inversion
register can be programmed to invert the polarity of the input register. The PCA9535 has an opendrain
interrupt output which is activated when any one of the GPIO changes from its corresponding
input port register state. The power on reset sets the registers to default values and initializes the
device state machine. The PCA9535 has three address pins A0, A1 and A2 which can be used to
configure the I²C bus slave address of the device. It allows up-to eight devices to share the same
I²C-bus/SMBus.
Features and benefits
• I²C-bus to parallel port expander
• Operating power supply voltage range of 2.3 V to 5.5 V
• Ultra low standby current consumption:
• 1 μA (maximum)
• Schmitt-trigger action allows slow input transition and better switching noise immunity at the
SCL and SDA inputs
• Vhys = 0.10 × VCC (typical)
• Noise filter on SCL and SDA inputs
• 5 V tolerant I/Os
• 16 I/O pins which power up configured in input state
• Open-drain active LOW interrupt output (INT)
• 400 kHz Fast-mode I²C-bus
• Internal power-on reset
• No glitch on power-up
• Latched outputs with 25 mA drive maximum capability for directly driving LEDs
• Latch-up performance exceeds 100 mA per JESD78, Class II
• ESD protection:
• HBM ANSI/ESDA/JEDEC JS-001 Class 2 exceeds 2000 V
• CDM ANSI/ESDA/JEDEC JS-002 Class C3 exceeds 1000 V
• TSSOP24 package: plastic thin shrink small outline package; 24 leads; body width 4.4 mm
• Specified from -40 °C to +85 °C