STWBC-EPTR datasheet(14/32 Pages) STMICROELECTRONICS

14 / 32 page

Electrical characteristics

STWBC-EP

14/32

DocID030747 Rev 1

Electrical characteristics

6.1

Parameter conditions

Unless otherwise specified, all voltages are referred to VSS. VDDA and VDD must be

connected to the same voltage value. VSS and VSSA must be connected to together with

the shortest wire loop.

6.2

Minimum and maximum values

Unless otherwise specified, the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with the ambient temperature at TA = 25 °C and TA = TA max. (given by

the selected temperature range).

6.3

Typical values

Unless otherwise specified, typical data are based on TA = 25 °C, VDD and VDDA = 5 V. They

are given only as design guidelines and are not tested. Typical ADC accuracy values are

determined by characterization of a batch of samples from a standard diffusion lot over the

full temperature range.

6.4

Typical curves

Unless otherwise specified, all typical curves are given as design guidelines only and are

not tested.

6.5

Typical current consumption

For typical current consumption measurements, VDD and VDDA are connected together as

shown in Figure 5.

STWBC-EPTR Datasheet(PDF) 14 Page - STMicroelectronics