SSD1852Z datasheet(33/55 Pages) ETC

33 / 55 page

SSD1852

Rev 1.0

01/2003

SOLOMON

9.24 Exit Power-save Mode

This command releases the chip from either Standby or Sleep Mode and return to normal

operation.

9.25 Software Reset

When the RESET instruction is issued, the following parameters are initialized:

Default Value

Descriptions

Page address

Column address

Display Start Line

GDDRAM page 0,D0

Internal Resistor Ratio

Gain = 3.45(IR0)

Contrast

20H

Data display length

FRC, PWM Mode

4FRC, 9PWM

White Palette

(0, 0, 0, 0)

Light Gray Palette

(0, 0, 0, 0)

Dark Gray Palette

(9, 9, 9, 9)

Black Palette

(9, 9, 9, 9)

9.26 Exit N-line Inversion

This command releases the chip from N-line inversion mode. The driving waveform will

be inverted once per frame after issuing this command.

9.27 Set Display Data Length

This two-byte command only valid when 3-wire SPI configuration is set by H/W input

(PS0=PS1=L). The second 8-bit is used to a number of display data byte (1-256) to be

transmitted. The next byte after the display data string is handled as a command.

9.28 Exit Modify-read

This command releases the modify-read mode and the column address return to its initial

value (before the set modify-read mode is set).

SSD1852Z Datasheet(PDF) 33 Page - List of Unclassifed Manufacturers