www.micropowerdirect.com

EMC Specifications

Parameter

Standard

Radiated Emissions

See Note 1

EN 55022

Class A

Conducted Emissions

See Note 1

EN 55022

Class A

ESD

EN 61000-4-2

Criteria B; ±4 kV Contact

RS

EN 61000-4-3

Criteria A; 10V/m

EFT

See Note 2

EN 61000-4-4

Criteria B; ±2 kV

Surge

See Note 3

EN 61000-4-5

Criteria B; ±2 kV

CS

EN 61000-4-6

Criteria A; 3 Vrms

Voltage Dips

EN 61000-4-29

Criteria B; 0% - 70%

Typical Connection

The diagram above illustrates a typical connection of the MB3000ERW

series for applications that require meeting EMC standards. The units do not

require external components to operate as specified. Some notes on this

diagram (starting with the input circuit) are:

1. It is recommended that an external fuse be used.The recommended fuse

is shown in the model chart on page 2.

2. An external MOV is recommended on the input to protect the unit in the

event of a surge. A recommended value is given in the table at right.

3. An external TVS is recommended on the input to protect the unit in the

event of a voltage spike. A recommended value is given in the table at

right.

electrolytic capacitor. Care must be taken in choosing this capacitor not

to exceed the capacitive load specification for the unit. Voltage derating

of capacitors should be 80% or above.

Notes:

1. All units are rated for EN 55022 (CE/RE) class A without external components.

They will meet class B with the addition of the MDCFM-xxW (or a similar discrete

filter circuit). Contact the factory for more information.

2. To meet the requirements of EN 61000-4-4 (±2 kV), external components are

needed.This can be done discretely, or with the addition of the MDCFM-xxW.

Contact the factory for more information.

3. To meet the requirements of EN 61000-4-5 (±2 kV), external components are

needed. This can be done discretely, or with the addition of the MDCFM-xxW.

Contact the factory for more information.

5. Recommended values for components are:

Component

MOV

S14K35

S14K60

56 µH

56 µH

TVS

SMCJ48A

SMCJ90A

330 µF/50V

330 µF/100V

4.7 µF/50V

2.2 µF/100V

1.0 mH

1.0 mH

1nF/2 kV

1nF/2 kV

400 uF/200V

400 uF/200V

6. Input noise and surge suppression modules are available for a

number of MPD DC/DC power supplies. A connection for one of

these modules is illustrated in the typical board layout shown at

Vin

(VDC)

Input

Capacitor

Vout

(VDC)

Output

Capacitor

24

100 µF

3.3

220 µF

5.0

220 µF

48

100 µF

9.0

100 µF

12

100 µF

15

100 µF

24

47 µF

the bottom of this page For pricing or full technical information,please contact

the factory.

7. In many applications simply

adding input/output capaci-

tors will enhance the input

surge protection and reduce

output ripple sufficiently. The

typical connection diagram above (& board layout

drawing below) illustrate their connection. Rec-

ommended capacitor values are given in the table.