Preliminary Datasheet LPA2010

LPA2010–00

May.-2016

www.lowpowersemi.com

Page 2 of 9

Functional Pin Description

MSOP-8/ Top View

Functional Pin Description

Pin

PIN No.

DESCRIPTION

SD

1

Shutdown pin. Active low.

BYP

2

Bypass pin. Connect a 1uF capacitor between this pin and GND.

INP

3

Positive input of amplifier.

INN

4

Negative input of amplifier.

VOP

5

Positive output of signal.

VDD

6

Voltage supply pin.

GND

7

Ground pin.

VON

8

Negative output of signal.

Absolute Maximum Ratings

Note 1



VDD Voltage to GND -------------------------------------------------------------------------------------------------------------- -0.3V to 6.0V



Other pin Voltage to GND --------------------------------------------------------------------------------------------------------- -0.3V to 5.5V



Maximum Junction Temperature ---------------------------------------------------------------------------------------------------------- 125°C



Operating Ambient Temperature Range (Ta) --------------------------------------------------------------------------------- -40℃ to 85°C



Maximum Soldering Temperature (at leads, 10 sec) --------------------------------------------------------------------------------- 260°C

Note 1.

Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress

ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections

of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

Thermal Information



Maximum Power Dissipation (PD,TA=25°C) --------------------------------------------------------------------------------------------- 1.0W



Thermal Resistance ( JA) ----------------------------------------------------------------------------------------------------------------- 120℃/W

ESD Susceptibility





Note 2.

The Human body model (HBM) is a 100pF capacitor discharged through a 1.5kΩ resistor into each pin. The testing is done according

JEDEC.

Note 3.

Machine Model (MM) is a 200pF capacitor discharged through a 500nH inductor with no series resistor into each pin. The testing is

done according JEDEC.

4

4

3

2

1

5

6

7

8

VDD

INN

SD

BYP

VOP

GND

VON

INP