LTM2885

6

2885fa

For more information www.linear.com/LTM2885

SYMBOL

PARAMETER

CONDITIONS

MIN

TYP

MAX

UNITS

Rated Dielectric Insulation Voltage

1 Minute (Derived from 1 Second Test)

6500

1 Second (Notes 5, 6, 7)

7800

Common Mode Transient Immunity

50

kV/µs

Maximum Working Insulation Voltage

(Note 2)

1000

690

Partial Discharge

5

pC

CTI

Comparative Tracking Index

IEC 60112 (Note 2)

600

Depth of Erosion

IEC 60112 (Note 2)

0.017

mm

DTI

Distance Through Insulation

(Note 2)

0.2

mm

Input to Output Resistance

(Notes 2, 5)

1

5

TΩ

Input to Output Capacitance

(Notes 2, 5)

6

pF

Creepage Distance

(Notes 2, 5)

14.6

mm

Note 1: Stresses beyond those listed under Absolute Maximum Ratings

may cause permanent damage to the device. Exposure to any Absolute

Maximum Rating condition for extended periods may affect device

reliability and lifetime.

Note 2: Guaranteed by design and not subject to production test.

Note 3: Maximum Data rate is guaranteed by other measured parameters

and is not tested directly.

Note 4: This µModule transceiver includes over temperature protection

that is intended to protect the device during momentary overload

conditions. Junction temperature will exceed 125°C when over

temperature protection is active. Continuous operation above specified

maximum operating junction temperature may result in device degradation

or failure.

Note 5: Device considered a 2-terminal device. Pin group A1 through C7

shorted together and pin group R1 through T7 shorted together.

Note 6: The rated dielectric insulation voltage should not be interpreted as

a continuous voltage rating.

Note 7: In accordance with UL1577, each device is proof tested for the

1 minute RMS rating by applying the equivalent RMS voltage multiplied by

an acceleration factor of 1.2 for one second.