HIP6301CBZ datasheet(12/17 Pages) RENESAS

12 / 17 page

HIP6301

FN4765 Rev 6.00

Page 12 of 17

December 27, 2004

Current Sensing and Balancing

Overview

The HIP6301 samples the on-state voltage drop across each

synchronous rectifier FET, Q2, as an indication of the

inductor current in that phase, see Figure 7. Neglecting AC

effects (to be discussed later), the voltage drop across Q2 is

simply rDS(ON)(Q2) x inductor current (IL). Note that IL, the

inductor current, is either 1/2, 1/3, or 1/4 of the total current

(ILT), depending on how many phases are in use.

The voltage at Q2’s drain, the PHASE node, is applied to the

RISEN resistor to develop the IISEN current to the HIP6301

ISEN pin. This pin is held at virtual ground, so the current

through RISEN is

The IISEN current provides information to perform the

following functions:

1. Detection of an overcurrent condition

2. Reduce the regulator output voltage with increasing load

current (droop)

3. Balance the IL currents in multiple channels

Overcurrent, Selecting RISEN

The current detected through the RISEN resistor is averaged

with the current(s) detected in the other 1, 2, or 3 channels.

The averaged current is compared with a trimmed, internally

generated current, and used to detect an overcurrent

condition.

The nominal current through the RISEN resistor should be

A at full output load current, and the nominal trip point for

overcurrent detection is 165% of that value, or 82.5

A

Therefore,

For a full load of 25A per phase, and an rDS(ON) (Q2) of

, RISEN = 2k.

The overcurrent trip point would be 165% of 25A, or ~ 41A

per phase. The RISEN value can be adjusted to change the

overcurrent trip point, but it is suggested to stay within

25%

of nominal.

Droop, Selection of RIN

The average of the currents detected through the RISEN

resistors is also steered to the FB pin. There is no DC return

path connected to the FB pin except for RIN, so the average

FIGURE 7. SIMPLIFIED FUNCTIONAL BLOCK DIAGRAM SHOWING CURRENT AND VOLTAGE SAMPLING

CURRENT

SENSING

COMPARATOR

PWM

CIRCUIT

AVERAGING

CURRENT

FROM

OTHER

CHANNELS

SAWTOOTH

GENERATOR

DIFFERENCE

RISEN

CORRECTION

ERROR

AMPLIFIER

COMP

REFERENCE

TO OTHER

CHANNELS

ISEN

RIN

RFB

VCORE

COMPARATOR

REFERENCE

TO OVER

CURRENT

TRIP

L01

PHASE

INDUCTOR

CURRENT(S)

FROM

OTHER

CHANNELS

PWM

DAC

HIP6301

VIN

ONLY ONE OUTPUT

HIP6601B

STAGE SHOWN

SENSING

rDS ON

 Q2



RISEN

------------------------------------

RISEN

rDS ON

 Q2



A

----------------------------------------------

HIP6301CBZ Datasheet(PDF) 12 Page - Renesas Technology Corp

HIP6301CBZ Datasheet(HTML) 12 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Datasheet Download

Link URL