ML9044 datasheet(21/55 Pages) OKI

21 / 55 page

¡ Semiconductor

ML9044

21/54

2) Large character patterns (5 ¥ 11 dots) (See Table 3–2.)

(1) A method of writing character patterns to the CGRAM from the CPU

The four CGRAM address bits 0 to 3 select one of the lines constituting a character pattern.

First, set the mode to increment or decrement from the CPU, and then input the CGRAM address.

Write each line of the character pattern code in the CGRAM through DB0 to DB7.

The data lines DB0 to DB7 correspond to the CGRAM data bits 0 to 7, respectively (see Table 3–

2). Input data “1” represents the ON status of an LCD dot and “0” represents the OFF status.

Since the ADC is automatically incremented or decremented by 1 after the data is written to the

CGRAM, it is not necessary to set the CGRAM address again.

The bottom line of a character pattern (the CGRAM address bits 0 to 3 are all “1”, which means

A in hexadecimal) is a cursor line. The ON/OFF pattern of this line is ORed with the cursor

pattern for displaying on the LCD. Therefore, the pattern data for the cursor position should be

all zeros to display the cursor.

Whereas the data given by the CGRAM data bits 0 to 4 with the CGRAM addresses 0 to A in

hexadecimal (set by the CGRAM address bits 0 to 3) is output as display data to the LCD, the data

given by the CGRAM data bits 5 to 7 or the CGRAM addresses B to F in hexadecimal is not. These

bits can be written and read as a RAM area.

(2) A method of displaying CGRAM character patterns on the LCD

The CGRAM is selected when the higher–order 4 bits of a character code are all zeros. Since bits

0 and 3 of a character code are not used, the character pattern “b” in Table 3–2 can be selected with

a character code “00”, “01”, “08” or “09” in hexadecimal.

When the 8–bit character code corresponding to a character pattern in the CGRAM is written to

the DDRAM, the character pattern is displayed in the display position specified by the DDRAM

address. (The DDRAM data bits 1 and 2 correspond to the CGRAM address bits 4 and 5,

respectively.)

ML9044 Datasheet(PDF) 21 Page - OKI electronic componets