This Data Sheet may be revised by subsequent versions

©2004 Eon Silicon Solution, Inc., www.essi.com.tw

or modifications due to changes in technical specifications.

12

EN25T80

Rev. A, Issue Date: 2006/11/6

The status and control bits of the Status Register are as follows:

WIP bit. The Write In Progress (WIP) bit indicates whether the memory is busy with a Write Status

Register, Program or Erase cycle. When set to 1, such a cycle is in progress, when reset to 0 no such

cycle is in progress.

WEL bit. The Write Enable Latch (WEL) bit indicates the status of the internal Write Enable Latch. When

set to 1 the internal Write Enable Latch is set, when set to 0 the internal Write Enable Latch is reset and

no Write Status Register, Program or Erase instruction is accepted.

BP2, BP1, BP0 bits. The Block Protect (BP2, BP1, BP0) bits are non-volatile. They define the size of the

area to be software protected against Program and Erase instructions. These bits are written with the

Write Status Register (WRSR) instruction. When one or both of the Block Protect (BP2, BP1, BP0) bits is

set to 1, the relevant memory area (as defined in Table 3.) becomes protected against Page Program (PP)

Sector Erase (SE) and , Block Erase (BE), instructions. The Block Protect (BP2, BP1, BP0) bits can be

written provided that the Hardware Protected mode has not been set. The Chip Erase (CE) instruction is

executed if, and only if, both Block Protect (BP2, BP1, BP0) bits are 0.

Mode1, Mode0 bits. Default value is SPI mode (00), user can change this value by change mode

commands to change the interface mode. This device also support SP2 mode (01).

SRP bit / OTP_LOCK bit

. The Status Register Protect (SRP) bit is operated in conjunction with the Write

Protect (WP#) signal. The Status Register Write Protect (SRP) bit and Write Protect (WP#) signal allow

the device to be put in the Hardware Protected mode (when the Status Register Protect (SRP) bit is set to

1, and Write Protect (WP#) is driven Low). In this mode, the non-volatile bits of the Status Register (SRP,

BP2, BP1, BP0) become read-only bits and the Write Status Register (WRSR) instruction is no longer

accepted for execution.

In OTP mode, this bit is served as OTP_LOCK bit, user can read/program/erase OTP sector as normal

sector while OTP_LOCK value is equal 0, after OTP_LOCK is programmed with 1 by WRSR command,

the OTP sector is protected from program and erase operation. The OTP_LOCK bit can only be

programmed once.

Note : In OTP mode, the WRSR command will ignore any input data and program OTP_LOCK bit to 1, user

must clear the protect bits before enter OTP mode and program the OTP code, then execute WRSR command

to lock the OTP sector before leaving OTP mode.