2. Select the LO/DO and Delay settings.

Method

Action

Result

Push Button

a. Release the buttons.

b. Click Static (-) or Dynamic (+) to toggle between choices:

•

Dynamic (+)—increment

•

Static (-)—decrement

a. The sensor is ready to select a new

setting combination.

b. Sensor steps between LO/DO and

Delay setting combinations, as shown

Figure 7 on page 7.

Remote Input

a. Wait > 8 seconds.

b. Enter sequential pulses to toggle between

choices:

•

Single-pulse—increment

•

Double-pulse—decrement

b.

T

or

T

T

T

Note: There is a LO/DO settings shortcut using the remote input. From Run mode, triple-pulse the remote

line. The sensor toggles between LO/DO settings on-the-fly, and continues in Run mode.

3. Enter the sensing beam color select mode from Setup mode.

Method

Action

Result

Push Button

From Setup mode, press and hold Dynamic (+) > 2 seconds.

The sensor displays the currently selected

sensing beam color combinations, as

shown Figure 8 on page 7.

The visible sensing beam also provides

indication of enabled sensing beam

color(s).

Remote Input

From Setup mode, four pulse the remote

input.

T

T

T

T

T

T

T

4. Enable/Disable sensing beam colors.

Method

Action

Result

Push Button

Click Static (-) or Dynamic (+) to toggle between choices:

•

Dynamic (+)—increment

•

Static (-)—decrement

The sensor steps between the possible

sensing beam color combinations, as

shown in Figure 8 on page 7.8

The visible sensing beam also provides

indication of enabled sensing beam

color(s).

Remote Input

Enter sequential pulses to toggle between choices:

•

Single-pulse—increment

•

Double-pulse—decrement

T

or

T

T

T

5. Return to Run mode.

Method

Action

Result

Push Button

a. Press and hold Static (-) for > 2 seconds to return to Setup mode.

b. Press and hold both push buttons > 2 seconds to return to Run mode OR

wait > 60 seconds.

The sensor returns to Run mode with

new settings.

These steps return to Run mode from

both Setup modes.

Remote Input

a. Four-pulse the remote line to return

to Setup mode.

b. Hold the remote line low > 2 seconds

to return to Run mode OR wait >60

seconds.

a.

T

T

T

T

T

T

T

b.

8 If the new color setting has only one sensing beam color enabled, the sensor will switch to that color for sensing.

If the new color setting has multiple sensing beam colors enabled, the sensor will use the color that was active prior to configuration; following

the next TEACH procedure, it will select the enabled sensing beam color that has the greatest contrast.

8

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 122928 Rev. D