STM8S003K3 datasheet(14/103 Pages) STMICROELECTRONICS

14 / 103 page

Product overview

STM8S003F3 STM8S003K3

14/103

DS7147 Rev 10

The size of the UBC is programmable through the UBC option byte (Table 13), in increments

of 1 page (64-byte block) by programming the UBC option byte in ICP mode.

This divides the program memory into two areas:

•

Main program memory: 8 Kbyte minus UBC

•

User-specific boot code (UBC): Configurable up to 8 Kbyte

The UBC area remains write-protected during in-application programming. This means that

the MASS keys do not unlock the UBC area. It protects the memory used to store the boot

program, specific code libraries, reset and interrupt vectors, the reset routine and usually

the IAP and communication routines.

Figure 2. Flash memory organization

Read-out protection (ROP)

The read-out protection blocks reading and writing from/to the Flash program memory and

data EEPROM memory in ICP mode (and debug mode). Once the read-out protection is

activated, any attempt to toggle its status triggers a global erase of the program memory.

Even if no protection can be considered as totally unbreakable, the feature provides a very

high level of protection for a general purpose microcontroller.

MS36408V1

Low density

Flash program

memory

(8 Kbytes)

Programmable

area from 64 bytes

(1 page) up to

8 Kbytes

(in 1 page steps)

Program memory area

Write access possible for IAP

UBC area

Remains write protected during IAP

Data EEPROM (128 bytes)

Option bytes

STM8S003K3 Datasheet(PDF) 14 Page - STMicroelectronics