Factsheet 01.002

July 2019

These specifications are subject to change without notice.

07/08/2019

© 2019 Greenliant

1

S71465-01

GLS FS0019 Rev. 00

GLS89SP032G3/064G3/128G3/256G3/512G3/001T3

Industrial Temp 2.5” SATA ArmourDrive™ PX Series

Features

 Industry Standard 2.5” SATA Host Interface

– SATA 1.5Gb/s, 3Gb/s and 6Gb/s

– SATA Revision 3.2

– ATA/ATAPI-8 compliant

– Supports 48-bit address feature set

 Performance

– Sequential data read: Up to 550 MB/s*

– Sequential data write: Up to 500 MB/s*

* measured using 128 KByte transfer size

 Power Management

– 5V power supply

– Host initialized power management (HIPM)

– Device initialized power management (DIPM)

 Power Specifications

– Active mode:

1TB: 1680mW (typical)

512GB: 1670mW (typical)

256GB: 1450mW (typical)

128GB: 1350mW (typical)

64GB: 1230mW (typical)

32GB: 1100mW (typical)

– Idle mode: < 325mW (typical)

– Slumber mode: < 16mW (typical)

– DevSleep mode (optional): < 5mW (typical)

 Reliability

– Mean Time Between Failures (MTBF):

More than 2 million hours

 Data Protection

– Secure Erase (data sanitization)

 Integrated Current Detector

– Protects from inrush current and generates

reset during power-up and power-down to

prevent inadvertent writes

 Native Command Queuing (NCQ)

– Up to 32 commands

 Supports SMART and TRIM Commands

 20-Byte Serial Number

– Factory pre-programmed unique ID

 Built-in ECC

– Uses advanced LDPC bit error detection and

correction optimized for 3D NAND

 NAND Configuration

– 3 bits per cell (3D TLC)

 Endurance

– 3K P/E cycles (typical)

 Operating Temperature Range

– Industrial: -40°C to 85°C

 2.5-inch Form Factor

– 100mm x 69.85mm x 7.00mm

 All Devices are RoHS Compliant

Product Description

The GLS89SP032G3 / 064G3 / 128G3 / 256G3 /

512G3 / 001T3 Industrial Temperature SATA 2.5”

ArmourDrive™ PX Series (referred to as 2.5”

ArmourDrive” in this factsheet) are high-performance,

high-reliability solid state drives. They combine 32, 64,

128, 256 or 512 GBytes, or 1 TByte of NAND flash

memory with an advanced Serial ATA (SATA)

controller in a standard 2.5-inch form factor housing.

2.5” ArmourDrive is ideal for applications that require

hot-swappable and reliable data storage. 2.5” SATA

solid state storage technology is widely used in

servers, laptops, network-attached storage, industrial

computers, navigation systems, test and

measurement instrumentation, multi-function printers,

security and surveillance equipment, digital signage

and networking systems. These removable solid state

drives (SSDs) surpass traditional hard disk drives

(HDDs) in their security, reliability, ruggedness and

low power consumption.

The SATA SSD controller with built-in advanced

NAND management firmware communicates with the

host through the standard SATA protocol. It does not

require any additional or proprietary software such as

the Flash File System (FFS) and Memory Technology

Driver (MTD). The firmware effectively optimizes the

use of NAND flash memory’s program/erase (P/E)

cycles and minimizes write amplification.

2.5” ArmourDrive’s advanced NAND management

technology improves endurance, enhances data

security and helps prevent data loss during

unexpected power failure events. This innovative

technology combines robust NAND controller

hardware error correction capabilities with advanced

wear-leveling algorithms and bad block management

to improve data reliability and significantly extend the

life of the product.