MCP3564-ESLASHST datasheet(62/108 Pages) MICROCHIP

62 / 108 page

MCP3561/2/4

DS20006181C-page 62

 2019-2021 Microchip Technology Inc.

These three Interrupt Status bits are independent of the

two other interrupt mechanisms (IRQ pin and IRQ

fully clocked. This enables the polling on the STATUS

byte as a possible interrupt management solution with-

out requiring to connect the IRQ pin in the system. All

Status bit values are latched together just after the

device address has been correctly recognized by the

chip. Any interrupt happening after the two first Status

bits have been clocked out will appear in the STATUS

byte of the subsequent communication sequence.

Figure 6-2

represents

the

beginning

each

communication with both COMMAND and STATUS

bytes depicted. After the STATUS byte is propagated,

the SDO pin will be placed in high-impedance for Fast

commands or Write commands and will transfer data

bytes for Read commands as long as the CS pin stays

logic low.

FIGURE 6-2:

SPI Communication Start (COMMAND on SDI and STATUS on SDO) when the

Device Address Matches/Does Not Match CMD[7:6].

Don’t Care

SCK

SDI

SDO

High-Z

Device Latches SDI on Rising Edge

SPI Mode 0,0

SPI Mode 1,1

Device

Address

Command

Type

Device

Address ACK

Interrupts

Status

High-Z

Device Address

Matches CMD[7:6]

High-Z

SDO

Device Address

does not Match

CMD[7:6]

Device Latches SDO on Falling Edge

MCP3564-E/ST Datasheet(PDF) 62 Page - Microchip Technology

MCP3564-E/ST Datasheet(HTML) 62 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL