MODEL: R3-GSLMP1

R3-GSLMP1 SPECIFICATIONS

ES-8275 Rev.2 Page 1/10

https://www.m-system.co.jp/

Remote I/O R3 Series

INTERFACE I/O MODULE

(For SLMP Client)

Functions & Features

• Serves as a gateway for allowing data of SLMP-compatible

devices to be handled by Network module that uses a

different protocol.

• Reads/writes data from/to the SLMP server.

• Recognized as analog and/or discrete I/O modules by

Network module according to the device configuration.

Typical Applications

• A gateway between SLMP and CC-Link.

109

[4.29]

27.5 [1.08]

130

[5.12]

mm [inch]

MODEL: R3-GSLMP1S[1]

ORDERING INFORMATION

• Code number: R3-GSLMP1S[1]

Specify a code from below for [1].

(e.g. R3-GSLMP1S/CE/Q)

• Specify the specification for option code /Q

(e.g. /C01)

COMMUNICATION MODE

S: Single

[1] OPTIONS (multiple selections)

Standards & Approvals

blank: Without CE

/CE: CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• PC configurator software (model: R3CON version 2.55 or

later)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

GENERAL SPECIFICATIONS

Connection

Ethernet: RJ-45 Modular Jack

Internal bus: Via the Installation Base (model: R3-BSx)

Internal power: Via the Installation Base (model: R3-BSx)

RUN contact output: M3 separable screw terminal

(torque 0.5 N·m)

Screw terminal: Nickel-plated steel

Isolation: Ethernet to internal bus or internal power to RUN

contact output

RUN indicator: Bi-color (green/red) LED

Green turns ON when SLMP communication is normal and

fieldbus communication on the R3 Network module side is

also normal; or

Red turns ON when receiving data.

(Indication selectable with DIP SW3-4.)

ERR indicator: Bi-color (green/red) LED

Green turns ON/blinks in communication errors (OFF with

wire breakdown; Green blinks with setting errors); or

Red turns ON when transmitting data.

(Indication selectable with DIP SW3-4.)

■ RUN CONTACT OUTPUT

RUN contact: Turns on while the green RUN LED is ON (only

when SLMP communication is normal and fieldbus

communication on the R3 Network module side is also

normal).

Rated load: 250 V AC @ 0.5 A (cos ø = 1)

30 V DC @ 0.5 A (resistive load)

(Less than 50 V AC to conform with EU Directive)

Maximum switching voltage: 250 V AC or 30 V DC

Maximum switching power: 250 VA (AC) or 150 W (DC)

Minimum load: 1 V DC @ 1 mA

When driving an inductive load, external contact protection

and noise quenching are recommended.

ETHERNET COMMUNICATION

Communication Standard: IEEE 802.3u

Transmission: 10BASE-T, 100BASE-TX