MODEL: R3-PD16B

R3-PD16B SPECIFICATIONS

ES-8390 Rev.5 Page 1/8

http://www.m-system.co.jp/

Remote I/O R3 Series

ONE-SHOT PULSE OUTPUT MODULE

(triac output, 16 points)

109

(4.29)

27.5 (1.08)

130

(5.12)

mm (inch)

MODEL: R3-PD16B[1][2]

ORDERING INFORMATION

• Code number: R3-PD16B[1][2]

Specify a code from below for each of [1] and [2].

(e.g. R3-PD16BW/Q)

• Specify the specification for option code /Q

(e.g. /C01/SET)

NO. OF CHANNELS

16: 16

OUTPUT

B: Triac

[1] COMMUNICATION MODE

S: Single

W: Dual

[2] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-8395)

CAUTION

The output triac may burn out if the load is shortcircuited

during operation. Install a fuse at each output terminal.

RELATED PRODUCTS

• Interface module (model: R3-Nx)

Output completion status is compatible with interface

modules model: R3-NC1, -NC3, -NE1, -NM1 and -NDx of

firmware version V2.00 or higher. Other interface modules

are not compatible. So, set I/O Mode as output (SW2-7: ON)

to use it.

Note: R3-NL1 and R3-NL2 are not available with this model.

GENERAL SPECIFICATIONS

Connection

Internal bus: Via the Installation Base (model: R3-BSx)

Output: M3 separable screw terminal (torque 0.5 N·m)

Internal power: Via the Installation Base (model: R3-BSx)

Screw terminal: Nickel-plated steel

Isolation: Output to internal bus or internal power

Output mode setting: One-Shot Output Mode, ON/OFF

Control Output Mode, Continuance Output Mode selectable

with DIP switch

Output data length: 16bit, 8bit selectable with DIP switch

(For ON/OFF Control Output Mode only)

I/O mode setting: Output Complete Status ON/OFF is

selectable with DIP switch

One-shot ON time setting: 0.1 to 25.6 sec. selectable with

DIP switch

ON/OFF control output setting: Swappable its pair with DIP

switch.

Output hold function: Setting for communication error with

side DIP SW (available in continuance output mode)

RUN indicator: Bi-color (red/green) LED;

Red when the bus A operates normally;

Green when the bus B operates normally;

Amber when both buses operate normally.

ERR indicator: Bi-color (red/ green) LED;

Green in normal operating conditions;

Red with abnormal configuration.

Output status indicator: Red LED; turns on with the output

ON.