ACE713C

High Efficiency 1.25MHz, 2.5A Boost Regulator

VER 1.2

2

Parameter

Symbol

Ratings

Units

-0.3~7

V

-0.3~7

V

-0.3~7

V

Peak SW Sink Current

2.5

A

Power Dissipation

SOT-23-6

mW

mW

Operating Junction Temperature Range

-40~150

℃

Storage Temperature

-40~125

℃

Lead Temperature (Soldering, 10 sec)

260

℃

Human Body Model - (HBM)

4000

V

Machine Model- (MM)

200

V

1.

Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device.

These are stress ratings only, and functional operation of the device at these or any other conditions beyond

those indicated under recommended operating conditions is not implied. Exposure to absolute-maximum-rated

conditions for extended periods my affect device reliability.

2.

All voltages are with respect to network ground terminal.

3.

Surface mounted on FR-4 Board using 1 square inch pad size, dual side, 1oz copper

4.

Surface mounted on FR-4 board using minimum pad size, 1oz copper

5.

ESD testing is performed according to the respective JESD22 JEDEC standard.

The human body model is a 100 pF capacitor discharged through a 1.5kΩ resistor into each pin. The machine

model is a 200pF capacitor discharged directly into each pin.

Caution

This integrated circuit can be damaged by ESD if you

don’t pay attention to ESD protection. Chi power

recommends that all integrated circuits be handled with appropriate precautions. Failure to observe

proper handling and installation procedures can cause damage. ESD damage can range from subtle

performance degradation to complete device failure. Precision integrated circuits may be more

susceptible to damage because very small parametric changes could cause the device not to meet its

published specifications.

Recommended Operating Conditions

Parameter

MIN

MAX

Units

2.7

5.5

V

3.0

5.5

V

-40

85

℃

-40

125

℃

(1) The ACE713C is guaranteed to meet performance specifications from 0°C to 70°C. Specifications over

the

–40°C to 85°C operating temperature range are assured by design, characterization and correlation with

statistical process controls.