MAX11259 datasheet(4/25 Pages) MAXIM

4 / 25 page

Maxim Integrated │ 4

www.maximintegrated.com

Evaluates: MAX11259

MAX11259PMB Peripheral Module

4) Connect the PC to the peripheral module via the

USB2PMB2 adapter board using a micro-USB cable.

5) Start the peripheral module software by opening its

icon in the

Start | Programs menu. The peripheral

module software appears as shown in Figure 1. From

the

Device menu select Standalone. Verify that the

lower left status bar indicates the EV kit hardware is

Connected.

6) Connect the positive terminal of the function genera-

tor to the CH0+ (J11-1) test point on the peripheral

module. Connect the negative terminal of the function

generator to the CH0- (J11-2) test point on the periph-

eral module.

7) Configure the signal source to generate a 100Hz,

1VP-P sinusoidal wave with +1V offset.

8) Turn on the function generator.

9) In the configuration group of the Device menu, select

Channel 0 and click

Convert in the serial interface

menu.

10) Click on the Scope tab.

11) Check the

Remove DC Offset checkbox to remove

the DC component of the sampled data.

12) Click the

Capture button to start the data analysis.

13) The peripheral module software appears as shown in

Figure 1.

14) Verify that the frequency, which is displayed on the

right, is approximately 100Hz. The scope image has

buttons in the upper right corner that allow zooming

in to detail.

MAX11259 Datasheet(PDF) 4 Page - Maxim Integrated Products