MSM511666C datasheet(8/16 Pages) OKI

8 / 16 page

8/16

¡ Semiconductor

MSM511666C/CL

Notes:

1. A start-up delay of 100

µs is required after power-up, followed by a minimum of eight

initialization cycles (RAS-only refresh or CAS before RAS refresh) before proper device

operation is achieved.

2. The AC characteristics assume tT = 5 ns.

3. VIH (Min.) and VIL (Max.) are reference levels for measuring input timing signals.

Transition times (tT) are measured between VIH and VIL.

4. This parameter is measured with a load circuit equivalent to 1 TTL load and 50 pF.

The output timing reference levels are VOH = 2.0 V (IOH = –2 mA) and VOL = 0.8 V (IOL

= 2 mA).

5. Operation within the tRCD (Max.) limit ensures that tRAC (Max.) can be met.

tRCD (Max.) is specified as a reference point only. If tRCD is greater than the specified

tRCD (Max.) limit, then the access time is controlled by tCAC.

6. Operation within the tRAD (Max.) limit ensures that tRAC (Max.) can be met.

tRAD (Max.) is specified as a reference point only. If tRAD is greater than the specified

tRAD (Max.) limit, then the access time is controlled by tAA.

7. tCEZ (Max.), tREZ (Max.), tWEZ (Max.) and tOEZ (Max.) define the time at which the

output achieves the open circuit condition and are not referenced to output voltage

levels.

8. tCEZ and tREZ must be satisfied for open circuit condition.

9. tRCH or tRRH must be satisfied for a read cycle.

10. tWCS, tCWD, tRWD, tAWD and tCPWD are not restrictive operating parameters. They are

included in the data sheet as electrical characteristics only. If tWCS ≥ tWCS (Min.), then

the cycle is an early write cycle and the data out will remain open circuit (high

impedance) throughout the entire cycle. If tCWD ≥ tCWD (Min.) , tRWD ≥ tRWD (Min.),

tAWD ≥ tAWD (Min.) and tCPWD ≥ tCPWD (Min.), then the cycle is a read modify write

cycle and data out will contain data read from the selected cell; if neither of the above

sets of conditions is satisfied, then the condition of the data out (at access time) is

indeterminate.

11. These parameters are referenced to the CAS leading edge in an early write cycle, and

to the WE leading edge in an OE control write cycle, or a read modify write cycle.

MSM511666C Datasheet(PDF) 8 Page - OKI electronic componets