F39-TGR-CVL-B-2-R datasheet(18/98 Pages) OMRON

18 / 98 page

xviii

Precautions for Correct Use

Observe the precautions described below to prevent operation failure, mal-

functions, or undesirable effects on product performance.

4-1

Installation environment

Do not install the MS4800 system in the following types of environments:

• Areas exposed to intense interference light, such as direct sunlight

• Areas with high humidity where condensation is likely to occur

• Areas where corrosive gases are present

• Areas exposed to vibration or shock levels higher than in the specification

provisions

• Areas where the product may come into contact with water

• Areas where the product may get wet with oil that can solve adhesive

Do not use radio equipment such as cellular phones, walkie-talkies, or trans-

ceivers near the MS4800 system.

4-2

Wiring and installation

• Make sure to perform wiring while the power supply is OFF. Otherwise,

the MS4800 system may fail to operate due to the diagnosis function.

• When replacing the cable connectors with other types of connectors, use

connectors that provide a proper grade of protection.

• Properly perform the wiring after confirming the signal names of all the

terminals.

• Do not operate the control system until 2 seconds or more (2,2 seconds

or more in case of series connection) after turning ON the power of the

MS4800 system.

• Be sure to route the MS4800 system cable separate from high-potential

power lines or through an exclusive conduit.

• When using a commercially available switching regulator power supply,

make sure to ground the FG terminal (frame ground terminal).

• Install the emitter and receiver so that their vertical direction should

match.

4-3

Cleaning

Do not use thinner, benzene, or acetone for cleaning, they affect the product's

resin parts and paint on the case.

4-4

Object detection

The MS4800 system cannot detect transparent and/or translucent objects.

F39-TGR-CVL-B-2-R Datasheet(PDF) 18 Page - Omron Electronics LLC