| Electronic Components Datasheet Search |
|
MCP9803-M/MSG Datasheet(PDF) 14 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
MCP9803-M/MSG Datasheet(HTML) 14 Page - Microchip Technology |
|
14 / 30 page ![]() MCP9800/1/2/3 DS21909C-page 14 2010 Microchip Technology Inc. 5.3 Registers The MCP9800/1/2/3 has four registers that are user-accessible. These registers are specified as the Ambient Temperature (TA) register, the Temperature Limit-set (TSET) register, the Temperature Hysteresis (THYST) register and device Configuration (CONFIG) register. The Ambient Temperature register is a read-only register and is used to access the ambient temperature data. The data from the ADC is loaded in parallel in the register. The Temperature Limit-set and Temperature Hysteresis registers are read/write registers that provide user-programmable temperature limits. If the ambient temperature drifts beyond the programmed limits, the MCP9800/1/2/3 outputs an alert signal using the ALERT pin (refer to Section 5.3.4.3 “ALERT Output Configuration” ). The device Configuration register provides access for the user to configure the MCP9800/1/2/3’s various features. These registers are described in further detail in the following sections. The registers are accessed by sending Register Point- ers to the MCP9800/1/2/3 using the serial interface. This is an 8-bit pointer. However, the two Least Significant bits (LSbs) are used as pointers and all other bits need to be cleared <0>. This device has addi- tional registers that are reserved for test and calibration. If these registers are accessed, the device may not perform according to the specification. The pointer description is shown below. FIGURE 5-2: Register Block Diagram. ALERT Output Control Logic ALERT Output Resolution Temperature THYST TSET Register Register Register Configuration Register One-Shot Shutdown Fault Queue Alert Polarity Alert Comp/Int REGISTER 5-1: REGISTER POINTER U-0 U-0 U-0 U-0 U-0 U-0 R/W-0 R/W-0 00 0 0 0 0 P1 P0 bit 7 bit 0 Legend: R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’ -n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown bit 7-2 Unimplemented: Read as ‘0’ bit 1-0 Px<1:0>: Pointer bits 00 = Temperature register (TA) 01 = Configuration register (CONFIG) 10 = Temperature Hysteresis register (THYST) 11 = Temperature Limit-set register (TSET) . |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |