9FG830

Eight Output Differential Frequency Generator for PCIe Gen3 and QPI

19

Innovate with IDT and accelerate your future networks. Contact:

www.IDT.com

For Sales

800-345-7015

408-284-8200

Fax: 408-284-2775

For Tech Support

408-284-6578

www.idt.com/go/support

Corporate Headquarters

Integrated Device Technology, Inc.

6024 Silver Creek Valley Road

San Jose, CA 95138

United States

DISCLAIMER Integrated Device Technology, Inc. (IDT) and its affiliated companies (herein referred to as “IDT”) reserve the right to modify the products and/or

specifications described herein at any time, without notice, at IDT’s sole discretion. Performance specifications and operating parameters of the described

products are determined in an independent state and are not guaranteed to perform the same way when installed in customer products. The information contained

herein is provided without representation or warranty of any kind, whether express or implied, including, but not limited to, the suitability of IDT's products for any

particular purpose, an implied warranty of merchantability, or non-infringement of the intellectual property rights of others. This document is presented only as

a guide and does not convey any license under intellectual property rights of IDT or any third parties.

IDT's products are not intended for use in applications involving extreme environmental conditions or in life support systems or similar devices where the failure

or malfunction of an IDT product can be reasonably expected to significantly affect the health or safety of users. Anyone using an IDT product in such a manner

does so at their own risk, absent an express, written agreement by IDT.

Integrated Device Technology, IDT and the IDT logo are trademarks or registered trademarks of IDT and its subsidiaries in the United States and other countries.

Other trademarks used herein are the property of IDT or their respective third party owners. For datasheet type definitions and a glossary of common terms, visit

www.idt.com/go/glossary. Integrated Device Technology, Inc.. All rights reserved.

Revision History

Rev.

Issue Date

Originator Description

Page #

A

7/13/2010

RDW

Initial release. Move to final

B

7/20/2010

RDW

1. Added PPM tables to DS for both 25M and 14.318M inputs

2. Added Test load figures

C

8/25/2010

RDW

1. Updated/reformatted Electrical Tables

2. Corrected Features/Benefits and General Description

3. Updated termination figures to include Fig 5. for REF output

Various

D

7/3/2013

D. C.

1. Update OE# Latency min/max values from 1 & 3 cycles to 2 & 5 cycles

respectively.

2. Update VDDA max current from 28 to 30mA for 100MHz and 400MHz.

3. Added typical values to Phase Jitter Parameters table.

Various

E

4/4/2017

RDW

1. Corrected Byte 5 Device ID from 83hex to 10 hex.

14