KPT02A10-36SWDN datasheet(28/31 Pages) ITT

28 / 31 page

KPT/KPSE

Miniature circular connectors

Subject to changes

Contact

Cable size

Strip

size

mm2 (AWG)

insulation

0,93-0,21 (20-24)

5,0 mm

1,91-0,60 (16-20)

6,5 mm

3,18-1,91 (12-14)

6,5 mm

14A4 Coax

RG179B/u

Contact insertion

5. Remove hardware from plug and receptacle. Slide

hardware over wire bundle in proper order for re-

assembly.

6. Use the proper contact insertion tool, and slide the

tool over the terminal end of the contact. The size 16

contact lies in the tool and the tool tip butts against the

contact shoulder. The rear, or insulation support, of the

size 20 contact butts against an internal shoulder in

the tool tip.

4. Release crimped contact and wire from tool. Be

certain the wire is visible thru inspection hole in contact.

7. Beginning from center cavity and working outwards,

insert wired contacts into rear of connector by hand

until the front of the contact shoulder is no more than

1/8" from the grommet. Holding the connector securely,

position tool behind contact. Push tool straight into

contact cavity until contact snaps into position. A light

pull on wire will assure that contact is locked securely.

Repeat for remaining contacts.

Contact extraction

10. Slide hardware back over wire bundle. Using pro-

per extraction tool or extraction end of proper insertion/

extraction tool, proceed as follows:

8. Use wire hole fillers or grommet sealing plugs to fill

any empty cavities and assemble hardware to rear of

plug or receptacle.

11. Use the proper extraction tool. There are two lines

on the clip sleeve which are vital to the contact rem-

oval process. The first index line is used for removing

Completion

9. Check face of plug or receptacle for proper contact

installation.

Crimping contacts

1. Strip wires according to the table above taking care

not to cut or nick strands.

2. Insert stripped wire into contact crimp pot. Wire must

be visible thru inspection hole.

3. Using correct crimp tool and locator, cycle the tool

once to be sure the indentors are open. Insert contact

and wire into locator. Squeeze tool handles firmly and

completely to insure a proper crimp. The tool will not

release unless the crimp indentors in the tool head

have been fully actuated.

pin contacts while the second index line is for removing

socket contacts. Carefully place the tool tip over the

contact to be extracted until the tool tip touches the

insulator face. Carefully rotate the tool until the index

line is slightly below the insulator face. Keep an even

pressure against tool body; push plunger forward with

thumb and index finger; and push the contact out

through the clip. Carefully remove extraction tool from

connector. Pull the wire by hand to complete the rem-

oval of the contact.

Please ask for our detailed

Assembly Instruction

Assembly Instructions

KPT02A10-36SWDN Datasheet(PDF) 28 Page - ITT Industries

KPT02A10-36SWDN Datasheet(HTML) 28 Page - ITT Industries

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Datasheet Download

Link URL