IDT7134LA55JB datasheet(9/11 Pages) IDT

9 / 11 page

IDT7134SA/LA

High-Speed 4K x 8 Dual-Port Static SRAM

Military, Industrial and Commercial Temperature Ranges

2720 drw 10

W "A"(1)

VALID

tWC

MATCH

VALID

MATCH

tWP

tDW

tWDD

tDDD

ADDR "A"

DATAIN "A"

DATAOUT "B"

ADDR "B"

tAW

Timing Waveform of Write Cycle No. 1, R/W Controlled Timing(1,5,8)

Timing Waveform of Write with Port-to-Port Read(1,2,3)

NOTES:

1. Write cycle parameters should be adhered to, in order to ensure proper writing.

2. CEL = CER = VIL. OE"B" = VIL.

3. Port "A" may be either left or right port. Port "B" is the opposite from port "A".

NOTES:

1. R/W or CE must be HIGH during all address transitions.

2. A write occurs during the overlap (tEW or tWP) of a CE =VIL and R/W = VIL.

3. tWR is measured from the earlier of CE or R/W going to VIH to the end-of-write cycle.

4. During this period, the I/O pins are in the output state, and input signals must not be applied.

5. If the CE = VIL transition occurs simultaneously with or after the R/W = VIL transition, the outputs remain in the High-impedance state.

6. Timing depends on which enable signal (CE or R/W) is asserted last.

7. This parameter is guaranteed by device characterization, but is not production tested. Transition is measured +500mV from steady state with the Output Test Load

(Figure 2).

8. If OE = VIL during a R/W controlled write cycle, the write pulse width must be the larger of tWP or (tWZ + tDW) to allow the I/O drivers to turn off data to be placed on the bus

for the required tDW. If OE = VIH during an R/W controlled write cycle, this requirement does not apply and the write pulse can be as short as the specified tWP.

2720 drw 11

tAW

tAS(6)

tDW

DATAIN

ADDRESS

tWC

tWP

DATAOUT

tWZ

(7)

(4)

(2)

tHZ

(7)

tLZ

(7)

tHZ

tWR

(3)

(7)

tDH

tOW

IDT7134LA55JB Datasheet(PDF) 9 Page - Integrated Device Technology

IDT7134LA55JB Datasheet(HTML) 9 Page - Integrated Device Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11

Datasheet Download

Link URL