RT6203ENGSP datasheet(18/21 Pages) RICHTEK

18 / 21 page

RT6203E

DS6203E-00 January 2019

www.richtek.com

is a registered trademark of Richtek Technology Corporation.

If the application calls for a higher ambient temperature

and may exceed the recommended maximum junction

temperature of 125

°C, care should be taken to reduce the

temperature rise of the part by using a heat sink or air

flow.

Resistance vs. Temperature

-50

-25

100

125

Temperature (°C)

RDS(ON)_H

RDS(ON)_L

Figure 6. RT6203E RDS(ON) vs. Temperature

Layout Considerations

Follow the PCB layout guidelines for optimal performance

of the device.



Keep the high-current paths short, especially at the

ground terminals. This practice is essential for stable,

jitter-free operation. The high current path comprising

of input capacitor, high-side FET, inductor, and the output

capacitor should be as short as possible. This practice

is essential for high efficiency.



Place the input MLCC capacitors as close to the VIN

and GND pins as possible. The major MLCC capacitors

should be placed on the same layer as the RT6203E.



SW node is with high frequency voltage swing and

should be kept at small area. Keep analog components

away from the SW node to prevent stray capacitive noise

pickup.



Connect feedback network behind the output capacitors.

Place the feedback components next to the FB pin.



For better thermal performance, to design a wide and

thick plane for GND pin or to add a lot of vias to GND

plane.

An example of PCB layout guide is shown from Figure 7.

RT6203ENGSP Datasheet(PDF) 18 Page - Richtek Technology Corporation

RT6203ENGSP Datasheet(HTML) 18 Page - Richtek Technology Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Datasheet Download

Link URL