CAT525

5

Doc. No. 2001, Rev. E

PIN DESCRIPTION

Pin

Name

Function

Maximum DPP 2 output voltage

Maximum DPP 1 output voltage

Power supply positive

4

CLK

Clock input pin

5

RDY/

BSY

Ready/Busy output

6

CS

Chip select

7

DI

Serial data input pin

8

DO

Serial data output pin

9

PROG

Non-volatile Memory Programming

Enable Input

10

GND

Power supply ground

11

Minimum DPP 1 output voltage

12

Minimum DPP 2 output voltage

13

Minimum DPP 3 output voltage

14

Minimum DPP 4 output voltage

15

DPP 4 output

16

DPP 3 output

17

DPP 2 output

18

DPP 1 output

19

Maximum DPP 4 output voltage

20

Maximum DPP 3 output voltage

DEVICE OPERATION

The CAT525 is a quad 8-bit configured digitally

programmable potentiometer (DPP/CDPP) whose

outputs can be programmed to any one of 256 individual

voltage steps. Once programmed, these output settings

are retained in non-volatile memory and will not be lost

when power is removed from the chip. Upon power up

the DPPs return to the settings stored in non-volatile

memory. Each confitured DPP can be written to and

read from independently without effecting the output

voltage during the read or write cycle. Each output can

also be

adjusted without altering the stored output

setting, which is useful for testing new output settings

before storing them in memory.

DIGITAL INTERFACE

The CAT525 employs a 3 wire serial, Microwire-like

control interface consisting of Clock (CLK), Chip Select

(CS) and Data In (DI) inputs. For all operations, address

and data are shifted in LSB first. In addition, all digital

data must be preceded by a logic “1” as a start bit. The

DPP address and data are clocked into the DI pin on the

clock’s rising edge. When sending multiple blocks of

information a minimum of two clock cycles is required

between the last block sent and the next start bit.

Multiple devices may share a common input data line by

selectively activating the CS control of the desired IC.

Data Outputs (DO) can also share a common line

because the DO pin is Tri-Stated and returns to a high

impedance when not in use.

CHIP SELECT

Chip Select (CS) enables and disables the CAT525’s

read and write operations. When CS is high data may be

read to or from the chip, and the Data Output (DO) pin is

active. Data loaded into the DPP wiper control registers

will remain in effect until CS goes low. Bringing CS to a

logic low returns all DPP outputs to the settings stored in

non-volatile memory and switches DO to its high

impedance Tri-State mode.

Because CS functions like a reset the CS pin has been

desensitized with a 30 ns to 90 ns filter circuit to prevent

noise spikes from causing unwanted resets and the loss

of volatile data.

CLOCK

The CAT525’s clock controls both data flow in and out of

the IC and non-volatile memory cell programming. Serial

data is shifted into the DI pin and out of the DO pin on the

clock’s rising edge. While it is not necessary for the clock

to be running between data transfers, the clock must be

operating in order to write to non-volatile memory, even

though the data being saved may already be resident in

the DPP wiper control register.

No clock is necessary upon system power-up. The

CAT525’s internal power-on reset circuitry loads data

from non-volatile memory to the DPPs without using the

external clock.

CDPP/DPP addressing is as follows:

DPP OUTPUT

A0

A1

00

10

01

11