| Electronic Components Datasheet Search |
|
WM8955LSEFL/R Datasheet(PDF) 44 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM8955LSEFL/R Datasheet(HTML) 44 Page - Wolfson Microelectronics plc |
|
44 / 46 page ![]() WM8955L Production Data w PD Rev 4.2 March 2006 44 HEADPHONE OUTPUT CONFIGURATION The analogue outputs LOUT1/ROUT1, LOUT2/ROUT2, and OUT3 can drive a 16 Ω or 32Ω headphone load, either through DC blocking capacitors, or DC coupled without any capacitor. Headphone Output using DC blocking capacitors DC Coupled Headphone Output (OUT3SW = 00) WM8955L C2 220uF LOUT1 ROUT1 HPGND = 0V C1 220uF WM8955L HPDCEN = 1 LOUT1 ROUT1 HPDC = AVDD/2 Figure 32 Recommended Headphone Output Configurations When DC blocking capacitors are used, then their capacitance and the load resistance together determine the lower cut-off frequency, fc. Increasing the capacitance lowers fc, improving the bass response. Smaller capacitance values will diminish the bass response. Assuming a 16 Ω load and C1 = 220 µF: fc = 1 / 2 π RLC1 = 1 / (2π x 16Ω x 220µF) = 45 Hz In the DC coupled configuration, the headphone “ground” is connected to the OUT3 pin, which must be enabled by setting OUT3 = 1 and OUT3SW = 00. As the OUT3 pin produces a DC voltage of AVDD/2 (=VREF), there is no DC offset between LOUT1/ROUT1 and OUT3, and therefore no DC blocking capacitors are required. This saves space and material cost in portable applications. It is recommended to connect the DC coupled headphone outputs only to headphones, and not to the line input of another device. Although the built-in short circuit protection will prevent any damage to the headphone outputs, such a connection may be noisy, and may not function properly if the other device is grounded. SPEAKER OUTPUT CONFIGURATION LOUT2 and ROUT2 can differentially drive a mono 8 Ω speaker as shown below. LOUT2 ROUT2 WM8955L ROUT2INV = 1 V SPKR = L-(-R) = L+R -1 LEFT MIXER RIGHT MIXER ROUT2VOL LOUT2VOL Figure 33 Speaker Output Connection The right channel is inverted by setting the ROUT2INV bit, so that the signal across the loudspeaker is the sum of left and right channels. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |