AT89C55WD datasheet(20/35 Pages) ATMEL

20 / 35 page

1921C–MICRO–3/05

AT89C55WD

19. Program Memory Lock Bits

The AT89C55WD has three lock bits that can be left unprogrammed (U) or can be programmed

(P) to obtain the additional features listed in the following table.

When lock bit 1 is programmed, the logic level at the EA pin is sampled and latched during reset.

If the device is powered up without a reset, the latch initializes to a random value and holds that

value until reset is activated. The latched value of EA must agree with the current logic level at

that pin in order for the device to function properly.

20. Programming the Flash

The AT89C55WD is shipped with the on-chip Flash memory array ready to be programmed. The

programming interface needs a high-voltage (12-volt) program enable signal and is compatible

with conventional third-party Flash or EPROM programmers.

The AT89C55WD code memory array is programmed byte-by-byte.

Programming Algorithm: Before programming the AT89C55WD, the address, data, and con-

trol signals should be set up according to the Flash programming mode table and Figures 21-1

and 21-2. To program the AT89C55WD, take the following steps:

Input the desired memory location on the address lines.

Input the appropriate data byte on the data lines.

Activate the correct combination of control signals.

Raise EA/V

PP to 12V.

Pulse ALE/PROG once to program a byte in the Flash array or the lock bits. The byte-

write cycle is self-timed and typically takes no more than 50 µs. Repeat steps 1

through 5, changing the address and data for the entire array or until the end of the

object file is reached.

Table 19-1.

Lock Bit Protection Modes

Program Lock Bits

Protection Type

LB1

LB2

LB3

No program lock features.

MOVC instructions executed from external program memory are

disabled from fetching code bytes from internal memory, EA is

sampled and latched on reset, and further programming of the Flash

memory is disabled.

Same as mode 2, but verify is also disabled.

Same as mode 3, but external execution is also disabled.

AT89C55WD Datasheet(PDF) 20 Page - ATMEL Corporation