738A INSTALLATION GUIDE

|

DIGITAL MONITORING PRODUCTS

5

ADEMCO COMPATIBILITY

Compatible Ademco Wireless Transmitters and Receivers

Table 4 and Table 5 list current Ademco transmitters and receivers that have been tested by DMP and are compatible

with the module. Other Ademco products have not been evaluated by DMP. The 738A module has not been tested by

UL.

The module supports up to 32 wireless zones. The module can deliver all 32 zones to a DMP panel regardless of the

number of zones assigned by the Ademco wireless receiver model number. For example, a Model 5881ENL 8‑Zone

Receiver delivers 32 wireless zones to the module.

RECEIVER MODEL NUMBER

XT30/XT50 SERIES

AND XR150/XR550 SERIES

5881ENL

8‑Zone Receiver

32 Zones

5881ENM

16 Zone Receiver

32 Zones

5881ENH

64‑Zone Receiver

32 Zones

Note: Dip switches on the 5881 series receiver must be set to zero.

Table 4: Ademco Receivers

SUPERVISED

ADEMCO TYPE

UNSUPERVISED

ADEMCO TYPE

5802MN Miniature Panic Button

BR or UR

5802 Panic Button

BR

5816 Window/Door

RF

5803 3‑Button

BR

5817 3‑Zone

RF

5804 4‑Button

BR

5890 Motion Detector

RF

5804BD 4‑Button *

BR

*

Note: For use with XT30/XT50 Series panels.

*

Note: For use with XT30/XT50 Series panels.

Table 5: Ademco Transmitters

Ademco 5800TM Transmitter Module

The 738A supports the Armed, Alarm, and Ready to Arm status LEDs on an Ademco 5804BD. This requires connecting

an Ademco 5800TM to an XT30/XT50 panel. When a 5800TM is connected as shown in Figure 4. the panel Armed,

Alarm, and Ready to Arm status displays on the Ademco 5804BD Wireless Key LED and sounder. Table 3 describes the

LED and sounder operation. Refer to the Ademco 5804BD Installation Instructions for proper button operation.

Ademco 5804BD Panic Buttons

Use 5804BD buttons A and C to send a panic signal to the DMP panel. Press the A and C buttons at the same time

for two seconds to send a Zone 19 Panic signal to the central station receiver. The zone name information sent to the

receiver contains the first address number that the module is answering.

Note: For use with XT30/XT50 panels. When programming the 5804BD into the panel, you must manually enter the

transmitter ID number in

ZONE INFORMATION.