Novodur H802

Acrylonitrile Butadiene Styrene (ABS)

Contact us:

Phone +49 (2133) 9309 – 168

INSTY.emea@ineos.com

www.ineos-styrolution.com

Page 3 of 3

Revision Date: 2016.01.17

SUPPLY FORM

Novodur® is delivered in the form of cylindrical, spherical, or cubical pellets. The bulk density of the pellets is from 0.55 to 0.65 g/cm³. Values

may differ for special grades. Standard Packaging unit: 25 kg PE-bag on palette, shrunk or wrapped with PE film. In addition, delivery in larger

units of up to 1000 kg (IBC = Intermediate Bulk Container) or silo trucks can be arranged. In dry areas with normal temperature control,

Novodur pellets can be stored for relatively long periods of time without any change in mechanical properties. With unstable colors, however,

storage over a number of years can give rise to some change in color. Under poor storage conditions, Novodur absorbs moisture, but this can

be removed by drying.

PRODUCT SAFETY

No adverse effects on the health of processing personnel have been observed where the products are correctly processed and the production

areas are suitably ventilated. For styrene, alpha-methylstyrene, acrylonitrile, and butyl acrylate the maximum allowable workplace

concentrations must be observed according to the pertaining national regulations. In Germany, the following limit values are valid TRGS 900

(Aug. 2004): styrene, MAK-value: 20 ml/m³; alpha-methylstyrene, MAK-value: 100 ml/m³; acrylonitrile, TRK-value: 3 ml/m³, and butyl acrylate,

MAK-value: 2 ml/m³ (1.7.2004). According to EU directive 67/548/EEC, Annex I (2001), acrylonitrile is classified as carcinogenic, category 2

(´substances which should be regarded as if they are carcinogenic to man´). Experience has shown that when Novodur® is processed

correctly with appropriate ventilation, the levels are far below the limits mentioned above. Inhalation of the vapors of degradation products

which can arise on severe overheating of the materials or during purging out should be avoided. Further information can be found in the

Novodur safety data sheets.

DISCLAIMER

The aforementioned data shall constitute the agreed contractual quality of the product sold by INEOS Styrolution at the time of passing of risk.

INEOS Styrolution does not make any further warranty, representation or guarantee of any kind, express or implied, regarding the suitability of

the product for any particular purpose or application and INEOS Styrolution disclaims all liability in connection therewith. The customer himself

is required to verify whether or not the product is suitable for the further processing or application intended and whether or not the product

complies with the relevant statutory requirements. Unless explicitly and individually otherwise agreed in writing, INEOS Styrolution's sole and

exclusive liability with respect to its products is set forth in INEOS Styrolution's General Terms and Conditions for Sale.