LTM4680 datasheet(19/36 Pages) AD

19 / 36 page

LTM4650-2

Rev. 0

For more information www.analog.com

APPLICATIONS INFORMATION

where VD appears to increase with temperature. It is com-

mon knowledge that a silicon diode biased with a current

source has an approximate –2mV/°C temperature rela-

tionship (Figure 10), which is at odds with the equation.

In fact, the IS term increases with temperature, reducing

the ln(ID/IS) absolute value and yielding an approximate

–2mV/°C composite diode voltage slope.

should be made to attenuate the ringing with the least

amount of power loss.

Temperature Monitoring

Measuring the absolute temperature of a diode is possible

due to the relationship between current, voltage and tem-

perature described by the classic diode equation:

ID =IS •e

η • VT

VD = η • VT •In

where ID is the diode current, VD is the diode voltage, η

is the ideality factor (typically close to 1.0) and IS (satura-

tion current) is a process-dependent parameter. VT can be

broken out into:

VT =

k • T

where T is the diode junction temperature in Kelvin, q is

the electron charge, and k is Boltzmann’s constant. VT

is approximately 26mV at room temperature (298K) and

scales linearly with Kelvin temperature. It is this linear

temperature relationship that makes diodes suitable tem-

perature sensors. The IS term in the previous equation is

the extrapolated current through a diode junction when

the diode has zero volts across the terminals. The IS term

varies from process to process, varies with temperature,

and by definition must always be less than ID. Combining

all of the constants into one term:

KD =

η • k

where KD = 8.62 • 10−5, and knowing ln(ID/IS) is always

positive because ID is always greater than IS, leaves us

with the equation that:

VD = T KELVIN

(

) •KD •In

Figure 10. Diode Voltage VD vs Temperature T (°C)

TEMPERATURE (°C)

–50 –25

0.3

0.5

0.8

0.4

0.7

0.6

100

46502 F10

125

To obtain a linear voltage proportional to temperature,

we cancel the IS variable in the natural logarithm term

to remove the IS dependency from the equation. This is

accomplished by measuring the diode voltage at two cur-

rents I1, and I2, where I1 = 10 • I2) and subtracting, we get:

∆VD = T(KELVIN)•KD •IN

– T(KELVIN)•KD •IN

Combining like terms, then simplifying the natural log

terms yields:

ΔVD = T(KELVIN) • KD • lN(10)

and redefining constant

K'D =KD •IN(10) =

198µV

yields

ΔVD = K'D • T(KELVIN)

LTM4680 Datasheet(PDF) 19 Page - Analog Devices

LTM4680 Datasheet(HTML) 19 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Datasheet Download

Link URL