93LC66BT-ESLASHMSG datasheet(9/28 Pages) MICROCHIP

9 / 28 page

DS21795C-page 9

93AA66A/B/C, 93LC66A/B/C, 93C66A/B/C

2.6

Erase/Write Disable and

Enable(EWDS/EWEN)

The 93XX66A/B/C powers up in the Erase/Write

Disable (EWDS) state. All Programming modes must be

preceded by an Erase/Write Enable (EWEN) instruction.

Once the EWEN instruction is executed, programming

remains enabled until an EWDS instruction is executed

or Vcc is removed from the device.

To protect against accidental data disturbance, the

EWDS

instruction can be used to disable all erase/write

functions and should follow all programming opera-

tions. Execution of a READ instruction is independent of

both the EWEN and EWDS instructions.

FIGURE 2-5:

EWDS TIMING

FIGURE 2-6:

EWEN TIMING

2.7

Read

The READ instruction outputs the serial data of the

addressed memory location on the DO pin. A dummy

zero bit precedes the 8-bit (If ORG pin is low or A-Version

devices) or 16-bit (If ORG pin is high or B-version

devices) output string. The output data bits will toggle on

the rising edge of the CLK and are stable after the

specified time delay (TPD). Sequential read is possible

when CS is held high. The memory data will automati-

cally cycle to the next register and output sequentially.

FIGURE 2-7:

READ TIMING

CLK

•••

TCSL

CLK

TCSL

•••

CLK

•••

High-Z

•••

93LC66BT-E/MSG Datasheet(PDF) 9 Page - Microchip Technology

93LC66BT-E/MSG Datasheet(HTML) 9 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Download

Link URL