ADA4062-4ACPZ-R2 datasheet(16/20 Pages) AD

16 / 20 page

ADA4062-2/ADA4062-4

Rev. B | Page 16 of 20

PHASE REVERSAL

Phase reversal occurs in some amplifiers when the input common-

mode voltage range is exceeded. When the voltage driving the

input to these amplifiers exceeds the maximum input common-

mode voltage range, the output of the amplifiers changes polarity.

Most JFET input amplifiers have phase reversal if either input

exceeds the input common-mode range.

For the ADA4062-x, the output does not phase reverse if one

or both of the inputs exceeds the input voltage range but remains

within the positive supply rail and 0.5 V above the negative

supply rail. In other words, for an application with a supply

voltage of ±15 V, the input voltage can be as high as +15 V

without any output phase reversal. However, when the voltage

of the inputs is driven beyond −14.5 V, phase reversal occurs

due to saturation of the input stage leading to forward biasing

of the gate-drain diode. Phase reversal in ADA4062-x can be

prevented by using a Schottky diode to clamp the input terminals

to each other. In the simple buffer circuit in Figure 63, D1

protects the op amp against phase reversal, and R limits the

input current that flows into the op amp.

+VSY

–VSY

10kΩ

ADA4062-x

IN5711

Figure 63. Phase Reversal Solution Circuit

TIME (40µs/DIV)

VSY = ±15V

VOUT

VIN

Figure 64. No Phase Reversal

ADA4062-4ACPZ-R2 Datasheet(PDF) 16 Page - Analog Devices