www.ti.com

Y2

A

INH

Y1

COM

5

2

7

6

1

SW

SW

NOTE A: For simplicity, the test conditions shown in Figures 1 through 4 and 6 through 10 are for the demultiplexer configuration. Signals may

be passed from COM to Y1 (Y2) or from Y1 (Y2) to COM.

COM

Y

Absolute Maximum Ratings

(1)

SN74AUC2G53

SINGLE-POLE DOUBLE-THROW (SPDT) ANALOG SWITCH OR

2:1 ANALOG MULTIPLEXER/DEMULTIPLEXER

SCES484B – AUGUST 2003 – REVISED JANUARY 2007

LOGIC DIAGRAM (POSITIVE LOGIC)

SIMPLIFIED SCHEMATIC, EACH SWITCH (SW)

over operating free-air temperature range (unless otherwise noted)

MIN

MAX

UNIT

–0.5

3.6

V

–0.5

3.6

V

–0.5

V

Control input clamp current

–50

mA

I/O port diode current

±50

mA

On-state switch current current

±50

mA

±100

mA

DCT package

220

θ

JA

DCU package

227

°C/W

YZP package

102

Storage temperature range

–65

150

°C

(1)

Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings

only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating

conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

(2)

All voltages are with respect to ground unless otherwise specified.

(3)

The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.

(4)

The package thermal impedance is calculated in accordance with JESD 51-7.

2

Submit Documentation Feedback