WM8580 datasheet(43/97 Pages) WOLFSON

43 / 97 page

Production Data

WM8580

PD Rev 4.3 August 2007

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

CLKSEL

08h

1:0

DAC_CLKSEL

DAC clock source

00 = MCLK pin

01 = PLLACLK

10 = PLLBCLK

11 = MCLK pin

R15

DAC

Control 1

0Fh

RX2DAC_MODE

DAC oversampling rate and power down

control (only valid when DAC_SRC = 00,

DAC1 data sourced from S/PDIF receiver)

0 = SFRM_CLK determines

oversampling rate, DACs 2/3 powered

down

1 = PAIFRX_LRCLK determines

oversampling rate, DACs 2/3 source

PAIF Receiver

Table 33 DAC Clock Control

ADC INTERFACE

The ADC_CLKSEL register selects the ADC clock source from ADCMCLK, PLLACLK, PLLBCLK, or

MCLK. However, if the S/PDIF receiver is active, PLLACLK and PLLBCLK are invalid for ADC

operation, so the choice is limited to ADCMCLK (default) or MCLK.

The rate that the ADC operates at is determined by the ADC Rate module. It calculates the rate

based on the digital routing setup. If the ADC is sourced by the PAIF Transmitter, PAIFTX_LRCLK is

used in the rate calculation. If the ADC is sourced by the SAIF Transmitter (and PAIF Transmitter

has another source), SAIF_LRCLK is used in the rate calculation. If the S/PDIF Transmitter (only) is

sourcing the ADC, then the rate is set by the ADC_RATE register bits.

The ADC clock source can be independent from the DACs and PLLs, however for optimum

performance, it is recommended that where possible, clock sources on the WM8580 are

synchronous. Performance may be degraded if this condition is not met.

Figure 27 ADC Clock Selection

WM8580 Datasheet(PDF) 43 Page - Wolfson Microelectronics plc

WM8580 Datasheet(HTML) 43 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97

Datasheet Download

Link URL