3.2

March 26, 2021

ES9016K2M Datasheet

ESS TECHNOLOGY, INC. 109 Bonaventura Drive, San Jose, CA 95134, USA Tel (408) 643-

8800 • www.esstech.com

26

ABSOLUTE MAXIMUM RATINGS

PARAMETER

RATING

Storage temperature

–65

C to +105C

Voltage range for digital input pins

–0.3V to DVCC+ 0.3V

ESD Protection

Human Body Model (HBM)

Machine Model (MM)

2000V

200V

WARNING:

Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not implied. Exposure

to absolute

–maximum–rated conditions for extended periods may affect device reliability.

WARNING: Electrostatic Discharge (ESD) can damage this device. Proper procedures must be followed to avoid ESD when handling this device.

RECOMMENDED OPERATING CONDITIONS

PARAMETER

SYMBOL

CONDITIONS

Operating temperature

TA

–20

C to +70C

Power Supply

Voltage

Current nominal

(Note 1)

Current standby

(Notes 1, 2)

Digital Power Supply Voltage

DVCC

+1.8V

 5%

+3.3V

 5%

13.0mA

14.2mA

0mA

0mA

Internal Digital Core supply

DVDD

+1.2V (typical)

External Digital Core Supply

DVDD

+1.3V

 5% (Note 3)

50mA

Analog Core Supply Voltage

VCCA (Note 4)

+3.3V

 5%

+1.8V

 5%

0.8mA

0mA

Analog Power Supply Voltage

AVCCDAC (Note 4)

+3.3V

 5%

+1.8V

 5%

8.0mA

0mA

Total Power

DVCC = +1.8V

DVCC = +3.3V

≤ 36mW

≤ 59mW

< 1mW

< 1mW

Notes:

(1) fs = 44.1kHz, external MCLK = 22MHz, I2S input, DAC output connected to current-to-voltage converter, internal DVDD, all external

supply voltages at nominal center values

(2) With RESETB held low after setting the soft_start bit in register 14 to 1’b0 to fully ramp the DAC outputs to ground

(3) Internal DVDD should be used except under the conditions described on page 7. External DVDD current measured at 192kHz sample rate

and MCLK = 80MHz.

(4) For correct operation, VCCA

≥ AVCCDAC.

DC ELECTRICAL CHARACTERISTICS

Symbol Parameter

Minimum

Maximum

Unit

Comments

VIH

High-level input voltage

DVCC / 2 + 0.4

V

VIL

Low-level input voltage

0.4

V

VOH

High-level output voltage

DVCC – 0.2

V

IOH = 100

A

VOL

Low-level output voltage

0.2

V

IOL = 100

A