7.2.1 Design Requirements

7.2.1.1 Power Considerations

Ensure the desired supply voltage is within the range specified in the Recommended Operating Conditions.

The supply voltage sets the device's electrical characteristics of the device as described in the Electrical

Characteristics section.

The positive voltage supply must be capable of sourcing current equal to the maximum static supply current, ICC,

listed in the Electrical Characteristics, and any transient current required for switching.

The ground must be capable of sinking current equal to the total current to be sunk by all outputs of the

CDx4AC(T)164 plus the maximum supply current, ICC, listed in the Electrical Characteristics, and any transient

current required for switching. The logic device can only sink as much current that can be sunk into its ground

connection. Ensure the maximum total current through GND listed in the Absolute Maximum Ratings is not

exceeded.

The CDx4AC(T)164 can drive a load with a total capacitance less than or equal to 50pF while still meeting all of

the data sheet specifications. Larger capacitive loads can be applied; however, it is not recommended to exceed

50pF.

The CDx4AC(T)164 can drive a load with total resistance described by RL ≥ VO / IO, with the output voltage and

current defined in the Electrical Characteristics table with VOL. When outputting in the HIGH state, the output

voltage in the equation is defined as the difference between the measured output voltage and the supply voltage

at the VCC pin.

Total power consumption can be calculated using the information provided in CMOS Power Consumption and

Cpd Calculation.

Thermal increase can be calculated using the information provided in Thermal Characteristics of Standard Linear

and Logic (SLL) Packages and Devices.

CAUTION

The maximum junction temperature, TJ(max) listed in the Absolute Maximum Ratings, is an additional

limitation to prevent damage to the device. Do not violate any values listed in the Absolute Maximum

Ratings. These limits are provided to prevent damage to the device.

CD54AC164, CD74AC164, CD54ACT164, CD74ACT164

SCHS240D – NOVEMBER 1998 – REVISED OCTOBER 2024

www.ti.com

12

Submit Document Feedback

Copyright © 2024 Texas Instruments Incorporated

Product Folder Links: CD54AC164 CD74AC164 CD54ACT164 CD74ACT164