PARAMETER

TEST CONDITIONS

VALUE

UNIT

DW-16 DBQ-16

VISO

Maximum withstanding

isolation voltage

VTEST = VISO , t = 60 s (qualification),

VTEST = 1.2 x VISO , t = 1 s (100% production)

5000

3000

VRMS

(1)

Creepage and clearance requirements should be applied according to the specific equipment isolation standards of an application.

Care should be taken to maintain the creepage and clearance distance of a board design to ensure that the mounting pads of

the isolator on the printed-circuit board do not reduce this distance. Creepage and clearance on a printed-circuit board become

equal in certain cases. Techniques such as inserting grooves and/or ribs on a printed-circuit board are used to help increase these

specifications.

(2)

This coupler is suitable for safe electrical insulation only within the safety ratings. Compliance with the safety ratings shall be ensured

by means of suitable protective circuits.

(3)

Testing is carried out in air to determine the surge immunity of the package.

(4)

Testing is carried out in oil to determine the intrinsic surge immunity of the isolation barrier.

(5)

Apparent charge is electrical discharge caused by a partial discharge (pd).

(6)

All pins on each side of the barrier tied together creating a two-terminal device.

ISO7740, ISO7741, ISO7742

SLLSEP4J – MARCH 2016 – REVISED OCTOBER 2024

www.ti.com

10

Submit Document Feedback

Copyright © 2024 Texas Instruments Incorporated

Product Folder Links: ISO7740 ISO7741 ISO7742